Abstract:A new facility for microdiffraction strain measurements and microfluorescence mapping has been built on beamline 12.3.2 at the advanced light source of the Lawrence Berkeley National Laboratory. This beamline benefits from the hard x-radiation generated by a 6 T superconducting bending magnet (superbend). This provides a hard x-ray spectrum from 5 to 22 keV and a flux within a 1 microm spot of approximately 5x10(9) photons/s (0.1% bandwidth at 8 keV). The radiation is relayed from the superbend source to a focus in the experimental hutch by a toroidal mirror. The focus spot is tailored by two pairs of adjustable slits, which serve as secondary source point. Inside the lead hutch, a pair of Kirkpatrick-Baez (KB) mirrors placed in a vacuum tank refocuses the secondary slit source onto the sample position. A new KB-bending mechanism with active temperature stabilization allows for more reproducible and stable mirror bending and thus mirror focusing. Focus spots around 1 microm are routinely achieved and allow a variety of experiments, which have in common the need of spatial resolution. The effective spatial resolution (approximately 0.2 microm) is limited by a convolution of beam size, scan-stage resolution, and stage stability. A four-bounce monochromator consisting of two channel-cut Si(111) crystals placed between the secondary source and KB-mirrors allows for easy changes between white-beam and monochromatic experiments while maintaining a fixed beam position. High resolution stage scans are performed while recording a fluorescence emission signal or an x-ray diffraction signal coming from either a monochromatic or a white focused beam. The former allows for elemental mapping, whereas the latter is used to produce two-dimensional maps of crystal-phases, -orientation, -texture, and -strain/stress. Typically achieved strain resolution is in the order of 5x10(-5) strain units. Accurate sample positioning in the x-ray focus spot is achieved with a commercial laser-triangulation unit. A Si-drift detector serves as a high-energy-resolution (approximately 150 eV full width at half maximum) fluorescence detector. Fluorescence scans can be collected in continuous scan mode with up to 300 pixels/s scan speed. A charge coupled device area detector is utilized as diffraction detector. Diffraction can be performed in reflecting or transmitting geometry. Diffraction data are processed using XMAS, an in-house written software package for Laue and monochromatic microdiffraction analysis.

The Advanced Photon Source X-ray Transmitting Beam-Position-monitor Tests at the National Synchrotron Light Source X-25 Beamline

The APS X-ray Undulator Photon Beam Position Monitor and Tests at CHESS and NSLS

Optimization of the Cavity Beam-Position Monitor System for the Shanghai Soft X-ray Free-Electron Laser User Facility

An X-ray beam profile monitoring system at a beamline front-end combining a single-crystal diamond film and energy discrimination using droplet analysis

A beam position monitor and slit combination for synchrotron radiation

A direct experimental comparison of single-crystal CVD diamond and silicon carbide X-ray beam position monitors

Synthetic Diamond-Based Position-Sensitive Photoconductive Detector Development for the Advanced Photon Source

Beamline Spectroscopy of Integrated Circuits With Hard X-ray Transition Edge Sensors at the Advanced Photon Source

Design of a Diamond-Crystal Monochromator for the LCLS Hard X-Ray Self-Seeding Project

Detection of High Flux Synchrotron Radiation Based on Diamond Detector for HEPS

Optimization of NSLS-II Blade X-ray Beam Position Monitors: from Photoemission type to Diamond Detector

Design of a Dedicated Beamline for X-Ray Microfocusing- and Coherence-Based Techniques at the Advanced Photon Source

Photon Beam Position Monitoring System by CCD Camera

Photon Beam Position Monitor for Hefei Light Source Undulator Beamline

Mechanical Design of a Missteered Beam Safety Monitor at the Advanced Photon Source

Precision White-Beam Slit Design for High Power-Density X-Ray Undulator Beamlines at the Advanced Photon Source

Conceptual Design for A Beamline for A Hard X-Ray Nanoprobe with 30 Nm Spatial Resolution

High Precision Positioning Mechanisms for a Hard X-ray Nanoprobe Instrument*

A Dedicated Superbend X-Ray Microdiffraction Beamline for Materials, Geo-, and Environmental Sciences at the Advanced Light Source

Beam Experiments with A Non-Intercepting Beam Induced Fluorescence Profile Monitor for the Ads Linac

An in-vacuum x-ray diffraction microscope for use in the 0.7-2.9 keV range