Abstract:Hypereutectic Al-Si-Cu coatings were prepared by supersonic atmospheric plasma spraying to enhance the surface performance of lightweight alloys. To find out optimum process conditions and achieve desirable coatings, this work focuses on the influence of three important parameters (in-flight particle temperature, impact velocity, and substrate temperature) on the collected splats morphology, coatings microstructure and microhardness. Results show that appropriate combinations of temperature and velocity of in-flight particles cannot only completely melt hypereutectic Al-Si-Cu particles, especially the primary Si phase, but also provide the particles with sufficient kinetic energy. Thus, the optimized coating consists of 98.6 % of fully-melted region with nanosized coupled eutectic and 0.9 % of porosity. Increasing the substrate deposition temperature promotes the transition from inhomogeneous banded microstructure to homogeneous equiaxed microstructure with a lower porosity level. The observations are further interpreted by a newly developed phase-change heat transfer model on quantitatively revealing the solidification and remelting behaviors of several splats deposited on substrate. Besides, phase evolutions including the formation of supersaturated alpha-Al matrix solid solution, growth of Si and Al2Cu phases at different process conditions are elaborated. An ideal microstructure (low fractions of unmelted/partially-melted regions and defects) together with solid solution, grain refinement, and second phase strengthening effects contributes to the enhanced microhardness of coating. This integrated study not only provides a framework for optimizing Al-Si based coatings via thermal spraying but also gives valuable insights into the formation mechanisms of this class of coating materials. (C) 2021 Published by Elsevier Ltd on behalf of The editorial office of Journal of Materials Science & Technology.

The Influence of Supersonic Plasma Spray Parameters on Flying Particles Velocity and Temperature

Research on In-Flight Property of Particles in Plasma Spray Forming

Effect of Processing Parameters on Plasma Jet and In-Flight Particles Characters in Supersonic Plasma Spraying

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Heat transfer characteristics of plasma spraying

Process Optimization and Influencing Factors of Supersonic High-Energy Plasma Spraying of Al2O3-PF Composite Coatings on Polymer Matrix Composite Surface

Influence of the Type of Nozzle on Particle Flattening and Coating Microstructure of Al_2O_3-3TiO_2

Effect of Spraying Parameters on the Microstructure and Mechanical Properties of Micro-Plasma Sprayed Alumina-Titania Coatings

Effect of a Spatially Fluctuating Heating of Particles in a Plasma Spray Process

Study of Flying Particles in Plasma Spraying

Effects of Spray Parameters on the Microstructure and Property of Al2O3 Coatings Sprayed by a Low Power Plasma Torch with a Novel Hollow Cathode

Modeling Influence of Basic Operation Parameters on Plasma Jet

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Influence of In-Flight Particle Characteristics on the Forming Quality

Effects of Spraying Parameters on the Velocity of HVOF-Sprayed Particles Based on the PIV Method

The Effect of Plasma Spray Parameters on the Quality of Al-Ni Coatings

Influence of in-flight particle characteristics and substrate temperature on the formation mechanisms of hypereutectic Al-Si-Cu coatings prepared by supersonic atmospheric plasma spraying

Influence of Particle Size on Microstructure and Properties of Al2O3 Coatings Deposited by Plasma Spraying

An Introduction And Progress Of A Novel Atmospheric Laminar Plasma Spray Method

In-Flight Particle Behavior in Internal Powder Injection Supersonic Plasma Spray

Numerical analysis of spraying process with high efficiency atmospheric supersonic plasma gun