Abstract:High-temperature superconducting (HTS) maglev owns the capability of passive stabilization and has the potential to operate at a high speed with low energy consumption. However, the excitation caused by the irregular surface and inhomogeneous magnetic field of the permanent magnet guideway (PMG) will result in vibration between the superconductors and PMG, which could lead to some stability problems such as drift. To study the reliability of HTS maglev systems under a long-term disturbance, a tailored experimental device composed of a vibration table, a fixture, and HTS maglev model was employed. The effects of field-cooling height (FCH), external excitation frequencies, and amplitudes on the levitation height drift were investigated. It is found that under the same operating conditions, large excitation amplitude, high frequency, and low FCH would lead to a greater levitation height drift. There are three kinds of drift trends, i.e., downward, upward, or downward at first and then upward, and the phenomenon of drifting upward is more likely to occur under small excitation amplitude, high frequency, and low FCH conditions. Meanwhile, two simulation models employing the flux flow model and the flux flow and creep model were applied respectively. The simulation results show that the flux flow and creep model are more consistent with the experimental phenomena and the flux flow has a greater influence on the drift in the initial time period, while the flux creep has a slighter impact on the drift for a long time. These researches reveal the levitation height drift rules of the HTS maglev system and introduce proper simulation model for levitation height drift so that this work provides a reference for the design and safe operation of HTS maglev vehicles.

Levitation forces of an uncentralized high temperature superconductor thrust bearings

Static Behavior of a Complex High Temperature Superconductor Thrust Bearings

Effect of permanent magnet's structure on static behavior of a superconducting thrust bearing

Design and Analysis of a Superconducting Induction Magnetic Levitation Device for Hydraulic Turbo-Generator

Transition Cooling Height of High-Temperature Superconductor Levitation System

Numerical Simulation of the Levitation Force of High-Tc Superconductors

Modeling of High- Tc Superconducting Bulk using Different Jc- T Relationships over Dynamic Permanent Magnet Guideway

Design and Analysis of Superconducting Magnets of a New Mixed Maglev Model

Analysis of Temperature Field Distribution of Magnetic-Fluid Bearing for High-Speed Trains

Levitation Characteristics of High-Temperature Superconducting Bulks of Different Orientations and Arrays

High-Tc Superconducting Bearings Design: Towards High-Performance Machines

Superconducting Magnetic Bearings Simulation using an H-formulation Finite Element Model

Characteristic and magnetic field analysis of a high temperature superconductor axial-flux coreless induction maglev motor

Levitation performance evolution of high-temperature superconducting maglev vehicle under electromagnetism-heat-force strong coupling

Modeling and Dynamic Performance of Distributed Force in High-Temperature Superconducting Pinning Magnetic Levitation

Levitation force measurement and characteristics analysis of double sided high temperature superconducting thin film device

Levitation Height Drifts of HTS Bulks under a Long-Term External Disturbance

Nonlinear Hysteresis Of Magnetic Force-Gap In Magnetic Levitation Systems With High-T-C Superconductor

Experimental Study of HTS Electromagnet and General Electromagnet

Influence of Flux Creep on Dynamic Behavior of Magnetic Levitation Systems with A High-T-C Superconductor

Transitions of force and relaxation in a high-temperature superconductor levitation system