Abstract:Existing obstacle avoidance systems do not consider the situation of hollowed-out obstacles. Therefore, in this paper, we design an assistive cane with visual odometry based on these requirements of the blind to aid them in attaining safe indoor navigation. The proposed device is portable, compact and adaptable. The assistive cane with visual odometry can be used not only to directly detect obstacles, but also to draw the attention of people around, providing multiple protection for the blind. In order to optimize the device parameters, we select the height of the camera and the speed of the voice broadcast as factors to design a complete factorial design, aiming to explore the parameter level that can make the passing time shortest and the success rate of obstacle avoidance highest. We invited two visually impaired people and two blindfolded students with normal vision as the experimental subjects. Each subject was required to conduct the experiments under nine combinations of device parameters. The subjects tried to avoid obstacles according to the voice prompts. The passing time and the success rate of obstacle avoidance were recorded. The experimental results show that the broadcast speed causes the significant effect to the success rate and both the two factors affect the passing time. In addition, we discuss the results of different subjects’ response surfaces and perceptual patterns and get the conclusion that different visual perceptual patterns, namely route representation and two different survey representations, have a certain impact on the setting of the optimal parameter level and the optimal passing time. The congenitally blind subject with route representation has the shortest optimal passing time in an unfamiliar environment, and the camera height should be set at the center of the hollowed-out obstacle, while the results are somewhat different for the acquired visual impairment subjects and the blindfolded normal vision subjects with survey representation. The camera height should be set between the center and the upper position of the obstacle. In summary, the camera height should be set at the center of the hollowed-out barrier and the broadcast speed should be set at the highest level. At the same time, the device parameters should be adjusted appropriately according to the visual perception pattern of users. Further researches are needed to analyze the perceptual patterns in depth.

Design of Ultrasound Guided Cane

Design of Guiding Blind Cane Based on GPS Positioning and Ultrasonic Detection

An intelligent blind people guide cane design based on Arduino

Design of Ultrasonic Guidance System for the Blind Based on C8051F060

Intelligent Cane for Assisting the Visually Impaired

A design of blind-guide crutch based on multi-sensors

Innovative Design of Intelligent Health Equipment for Helping the Blind in Smart City

Development and design of an intelligent guide stick for the blind

Design of Smart Cane with Integrated Camera Module for Visually Impaired People

DESIGN OF AN INTELLIGENT ELECTRIC VEHICLE VISUALLY CHALLENGED PERSON

Design and Optimization of an Assistive Cane with Visual Odometry for Blind People to Detect Obstacles with Hollow Section

Design of Electronic Guide Dog Based on User Experience

Enhancing Mobility and Safety: A Smart Walking Cane for Visually Impaired Individuals with Ultrasonic Sensor, Infrared, and GSM Module

Guidance device for visually impaired people based on ultrasonic signals and open hardware

Study of methods for identifying obstacles using electronic guide device

Design of Smart Walking Shoe for Visually Impaired People

An Intelligent based System for Blind People Monitoring in a Smart Home

Voice Warning to Identify Distance to Obstacles on Smart Cane for Blind People

Design and Implementation of an Intelligent Assistive Cane for Visually Impaired People Based on an Edge-Cloud Collaboration Scheme

RFID-Based Road Guiding Cane System for the Visually Impaired.

Design a Smart Cane for Visually Impaired Individuals’ Assistance