Abstract:More than half of the discovered hydrocarbon reservoirs in the world are the oil-wet carbonates. Enhanced oil recovery (EOR) from these reservoirs is challenging because of their tendency to retain oil at the rock surface. The use of low salinity (LS) water injection to recover more oil from these types of oil reservoirs has been recommended by several researchers. There are possible mechanisms concerning LS water flooding that have been introduced in the literature; a distinct lack of experimental investigation to enhancing the efficiency of this method is still felt. In this work, a detailed and comprehensive study was carried out on using LS + surfactant (LSS) to improve the surface and interface properties of oil + water + calcite rock samples. In the first step, the point of zero charge of the rock sample was determined. Then, the effect of different salts including MgCl2, CaCl2, and Na2SO4 at different concentrations on improving the oil-water interfacial tension and wettability alteration of the rock surfaces was investigated in the presence and absence of a cationic surfactant, cetyl methylammonium bromide (CTAB), in the operational range of pH. Emulsion formation and adsorption measurement tests were performed for a deep investigation of the performance of the cationic surfactant in the presence of different salts. Finally, waterflooding experiments were carried out and the water/oil relative permeabilities, amount of recovery and wettability alteration were thoroughly investigated for three different injection scenarios. The results showed that the co-presence of magnesium, calcium and sulfate ions all in the presence and absence of CTAB surfactant causes a significant reduction in IFT and contact angle values, especially at the lower ranges of salinity. The addition of divalent cations, i.e., Mg2+ and Ca2+, could reduce the amount of surfactant adsorbed on the calcite rock surfaces, especially in the low ranges of salinities. Also, in flooding tests, an increase in differential pressure between the inlet and outlet faces of the core samples from about 2.9 MPa for LS to about 4.7 MPa for LSS flooding, at the breakthrough time, was observed which was related to the formation of water in oil emulsions during LSS flooding. Comparison of the ratio of the residual to initial oil saturation (Sor/Soi) for different flooding scenarios (i.e., injection of saline water (SW), LS and LSS solutions) indicates that as the salinity of water reduces, the efficiency of CTAB surfactant in improving oil recovery increases.

Effect of Divalent Cations and Surfactants on Silica−Bitumen Interactions

Effect of Heavy Constituent in Crude Oil on Wettability Change of Sandstone

Adsorption of cationic-anionic surfactant mixtures on silica gel/water and silica gel/mineralized water interfaces

Molecular dynamics study of the effect of inorganic salts on the monolayer of four surfactants at the oil/water interface

Probing the surface forces between air bubbles and bitumen via direct force Measurements: Effects of aqueous chemistry

Study of the Role of Sodium Citrate in Bitumen Liberation

Effects of mineral surface silanization and bitumen coating on its filtration from an aqueous slurry

Understanding the effects of salinity on bitumen-calcite interactions

Molecular insights into oil detachment from hydrophobic quartz surfaces in clay-hosted nanopores during steam-surfactant co-injection

The effect of clay type and solid wettability on bitumen extraction from Canadian oil sands

Influence of silane-hydrolysate coupling agents on bitumen–aggregate interfacial adhesion: An exploration from molecular dynamics simulation

Surfactants Enhanced Heavy Oil–Solid Separation from Carbonate Asphalt Rocks-Experiment and Molecular Dynamic Simulation

A mechanistic experimental study on the combined effect of Mg2+, Ca2+, and SO42- ions and a cationic surfactant in improving the surface properties of oil/water/rock system

Effect of Anionic Surfactants on the Oil-Water-Rock Interactions by an Improved Washburn Method

Molecular interactions at the interface between asphaltene and different substrates in the presence of electrolyte

Insight into the Interfacial Behavior of Surfactants and Asphaltenes: Molecular Dynamics Simulation Study

Spotlight onto surfactant–steam–bitumen interfacial behavior via molecular dynamics simulation

Effect of bivalent cations on the interfacial tensions of extended anionic surfactant solutions

Molecular interaction between asphaltene and quartz with different surface wettability: A combined study of experimental measurement and theoretical calculation

Understanding weathering of oil sands ores by atomic force microscopy

Influence of sea salt on the interfacial adhesion of bitumen–aggregate systems by molecular dynamics simulation