Abstract:The production of antibiotics typically consists of fermentation, removal of biomass, solvent extraction, and crystallization. Vacuum rotary filtration or other conventional filtration systems and microfiltration are used to remove the biomass, but the biomass removal step fails to remove macromolecules including polysaccharides and proteins which may act as emulsifiers causing emulsion in the subsequent solvent extraction process, and reducing the process efficiency and product quality. In this work, an attempt was made to remove these “emulsifiers” before solvent extraction using ultrafiltration (UF). Bench and pilot scale spiral wound membrane modules with the MWCO of 5, 20 and 50 kDa were tested to treat benzylpenicillin (Pen G) broth following microbe removal. The UF permeates were subsequently fed to solvent extraction (acidic extraction at pH 2.0). The experimental results showed that UF could significantly improve the extraction operation in terms of phase separation, elimination of the need for any de-emulsifier or wet agent, and increase extraction recovery and product quality. Similar improvements from UF were observed in the extractions of erythromycin and medmycin (alkaline extraction at pH 10.0 and 8.7, respectively). The experimental results show that UF is an alternative to the use of de-emulsifier or other wet agent to obtain good phase separation even by gravity without centrifugal extractor in solvent extractions of Pen G, erythromycin and medmycin. The mechanisms of the improvement of extraction were discussed based on the experimental results on characterizing the feed and permeate solutions of UF. And it was concluded that there existed bioemulsifiers in antibiotic fermentation broth and UF could successfully remove them and hence could improve the extraction operation.

A broth-froth recovery seperator application in avermectins production by Streptomyces avermitilis

Enhancement and Selective Production of Avermectin B by Recombinants of Streptomyces Avermitilis Via Intraspecific Protoplast Fusion

Novel strategy for depolymerization of avermectin fermentation residue to value-added amino acid product

AVERMECTIN PRODUCTION BY SOLID STATE FERMENTATION-A NOVEL APPROACH

Raising the avermectins production in Streptomyces avermitilis by utilizing nanosecond pulsed electric fields (nsPEFs)

Effect of Mycelial Morphology on Bioreactor Performance and Avermectin Production of Streptomyces Avermitilis in Submerged Cultivations

Application of combined physicochemical and biological processes for enhanced treatment of avermectin fermentation wastewater.

Yeast screening from avermectins wastewater and investigation on the ability of its fermentation

Kinetics of Streptomyces avermitilis by batch fermentation and its rheological properties model in industrial-scale production

Toward High-Efficiency Production of Biosurfactant Rhamnolipids Using Sequential Fed-Batch Fermentation Based on a Fill-and-draw Strategy

Effect of Inoculation Methods on Avermectin Fermentation by Streptomyces Avermilitis

Fenton-Anoxic–Oxic/MBR Process As a Promising Process for Avermectin Fermentation Wastewater Reclamation

The analysis of fluid properties during avermectin fermentation

Overexpression of Ribosome Recycling Factor Causes Increased Production of Avermectin in Streptomyces Avermitilis Strains

[Effect of Nitrogen on Avermectins Biosynthesis and Its Fermentation Optimization Based on Carbon-Dioxide Evolution Rate].

Efficient Preparation of Bafilomycin A1 from Marine Streptomyces lohii Fermentation Using Three-Phase Extraction and High-Speed Counter-Current Chromatography

Application of ultrafiltration to improve the extraction of antibiotics

Reverse Biological Engineering Of Hrdb To Enhance The Production Of Avermectins In An Industrial Strain Of Streptomyces Avermitilis

Screening for Antifoam with High Performances Based on Its Physical and Physiological Effects on the Fermentation of Biotechmycin

Oxygen Uptake Rate (our) Control Strategy for Improving Avermectin B-1a Production During Fed-Batch Fermentation on Industrial Scale (150 M(3))

Medium optimization for the production of avermectin B1a by Streptomyces avermitilis 14-12A using response surface methodology.