Abstract:Pipelines are widely used in energy power system including thermal power plants and nuclear power plants. In the power system, especially nuclear power plants, as thermal stratification characteristic of nonuniform temperature distribution in the pipe and thermal fatigue such as the low cycle thermal fatigue due to existence of the cycle thermal stress are inevitable, the pipe line system can be destroyed easily and thus affect the normal operation of the power plants. In order to study the pipeline thermal fatigue, the pipeline thermal stress needs to be calculated and therefore the temperature distributions especially the inner wall temperature was needed. The outer wall temperature and working fluid temperature can be obtained with installing measuring tools. The key and difficult point is the estimation of the inner temperature distribution of the pipe. At the same time, in the practical engineering, the pipeline structure with special safety requirements or higher requirements for structural completeness are not allowed to be destroyed by the measuring equipment. Based on the consideration above, this paper presents a method of solving the inverse heat conduction problem, which means the inner temperature distributions can be derived by the outer wall temperature distributions. For the pipe inverse heat conduction problem, this paper applies numerical analysis as the main way. Firstly, the method for transient inverse heat conduction problems applying separation of variables and Duhamel's theorem is established. As the effects of the random error on the measured outer wall temperature are inevitable, the measured data need to be smoothed before used as an input. The Gram orthogonal polynomial method based on the digital filtering theory is applied in this paper to accomplish the smoothing process. The inverse process is accomplished by using MATLAB programming. Then this method is verified in the experiment with high temperature and high pressure. In order to directly validate the accuracy of the inverse analysis, for the test section, not only the transient outer wall temperature and fluid temperature were measured, but also the time dependent middle layer temperature were measured. Then the middle layer temperature obtained from inverse calculation was compared with the measured data from the experiment. The calculated results show that the accuracy of this method is high. The temperature distributions along the radical direction can be obtained quickly and accurate instantaneous heat load for the structural stress analysis and thermal fatiglie analysis can be provided using this method. (CSPE)

A Nonlinear Solution of Inverse Heat Conduction Problem for Obtaining the Inner Heat Transfer Coefficient

A numerical method for two-dimensional nonlinear transient inverse heat conduction problems for orthotropic material

A Solution to the Two‐dimensional Inverse Heat Conduction Problem

A Least-Squares Solution to Nonlinear Steady-State Multi-Dimensional IHCP

A two-dimensional inverse heat conduction problem for simultaneous estimation of heat convection coefficient, fluid temperature and wall temperature on the inner wall of a pipeline

A Numerical Solution For The Transient Inverse Heat Conduction Problem

Two Dimensional Numerical Solution for Nonlinear Inverse Steady Heat Conduction

Analytical Solution of Heat Conduction for Hollow Cylinders with Time-Dependent Boundary Condition and Time-Dependent Heat Transfer Coefficient

A two-dimensional inverse heat conduction problem in estimating the fluid temperature in a pipeline

Non-linear unsteady inverse boundary problem for heat conduction equation

Method of Fundamental Solution for an Inverse Heat Conduction Problem with Variable Coefficients

Estimation of Unknown Boundary Heat Flux in Laminar Circular Pipe Flow Using Functional Optimization Approach: Effects of Reynolds Number

Solution to Two-Dimensional Steady Inverse Heat Transfer Problems with Interior Heat Source Based on the Conjugate Gradient Method

Inversion of the Third Boundary Condition on the Inner Wall of a Two-dimensional Pipe Based on Inverse Heat Conduction Problems

Robust Inverse Approach for Two-Dimensional Transient Nonlinear Heat Conduction Problems

Prediction Identification Method of Time-Varying Internal Heat Source Based on Inverse Heat Transfer Problem

Solving of Two-Dimensional Unsteady-State Heat-Transfer Inverse Problem Using Finite Difference Method and Model Prediction Control Method

Determination of the Convective Heat Transfer Coefficient in Three-Dimensional Inverse Heat Conduction Problems

Solution to inverse natural convection problem using experimental data

Solution of inverse nonlinear heat transfer problem based on the reduced order model

INVERSE HEAT CONDUCTION PROBLEM OF DEDUCING INNER WALL TEMPERATURE BY USING CONJUGATE GRADIENT METHOD