Abstract:Under the background of dual-carbon target, the circulating fluidized bed combustion technology, as an important part of coal-fired power generation, realizes an efficient and clean utilization of inferior fuel and is also a main force to participate in deep peak regulation of power grid in the future. However, CFB boilers still have a lot of room for improvement in load regulation rate, NO x emission control at deep low and low loads, and heating surface wear. Therefore, the powdered coal circulating fluidized bed（PC-CFB） combustion technology is proposed. By reducing the fuel particle size from the wide sieve distribution of 0-10 mm to a narrow sieve distribution of 0-1 mm, a sufficiently high circulating flow rate can be achieved at a low bed stock. Regulating chemical reactions through flow regimes, the reducing atmosphere needed for low-NO x combustion is strengthened, and the residence time of fine limestone in the furnace is extended, the combustion performance of the boiler can also be improved. More importantly, the rate of change in chemical reaction, i.e. heat release, increases due to the decrease of fuel particle size. Supplemented by cyclic interventions that can increase the rate of change in heat transfer rate, the combination of which can improve the rate of load regulation. The change of fuel particle size inevitably leads to the reduction of bed particle size, and significantly improves the deep low load capability and the in-furnace control of NO x emissions at low loads. This idea is confirmed by the modelling prediction, which shows that when the range of fuel particle size is reduced from the conventional size distribution to 0-1 mm, the average bed particle size decreases greatly and the material concentration in the dilute phase zone increases, and the circulating flow rate increases by about 27%. The reducing atmosphere in the furnace is enhanced, and the original emission concentration of NO x is reduced by about 35%. The improved performance of the circulation system can prolong the residence time of fine limestone in the furnace, improve the efficiency of desulfurization reaction, and reduce the original SO 2 emission concentration under the same conditions of calcium-sulfur ratio and NO x emission. Meanwhile, the combustion efficiency is significantly improved, the carbon content of bottom slag is reduced by 89%,and the heat loss of incomplete solid combustion is reduced by 52%,indicating that PC-CFB combustion technology has more advantages in enhancing the operational flexibility of CFB boilers, strengthening the low-NO x combustion, and improving the combustion performance.

The Prospect of Co-combustion of Biomass in the CFB Boiler

Co-Combustion of Biomass with Bituminous Coal in a CFB Boiler

Simulation of biogas co-combustion in CFB boiler: Combustion analysis using the CPFD method

Numerical simulation of biomass high-ratioco-firing in a pre-pyrolysis pulverized coal industrial boiler

Numerical Simulation on Combustion Characteristics of Co-Firing Biomass Syngas and Coal in a 660 MW Utility Tower Boiler

Technical-economic-environmental analysis of biomass direct and indirect co-firing in pulverized coal boiler in China

Progress of circulating fluidized bed combustion technology in China: a review

Future of Circulating Fluidized Bed Combustion Technology in China for Carbon Neutralization

Accelerate Large-Scale Biomass Residue Utilization via Cofiring to Help China Achieve Its 2030 Carbon-Peaking Goals

Study on the Co-combustion Characteristics and Synergistic Effect of Semi-Coke and Dust Coal Produced from Biomass Briquette in Fluidized Bed Gasification

Prospects for the Low Pollutant Emission Control of Circulating Fluidized Bed Combustion Technology

Experimental Investigation on the Combustion and Heat Transfer Characteristics of Wide Size Biomass Co-Firing in 0.2 MW Circulating Fluidized Bed

Computational Particle Fluid Dynamics Simulation on Combustion Characteristics of Blended Fuels of Coal, Biomass, and Oil Sludge in a 130 T H−1 Circulating Fluidized Bed Boiler

Experimental investigation on biomass co-firing in a 300 MW pulverized coal-fired utility furnace in China

Comparative Study on Biomass Power Generation Technologies

Powdered Coal Circulating Fluidized Bed Combustion Technology

Development of Biomass-Fired Circulating Fluidized Bed Boiler with High Steam Parameters Based on Theoretical Analysis and Industrial Practices

Study of Briquetted Biomass Co-Firing Mode in Power Plants

Numerical Study of Co-firing Biomass with Lean Coal under Air–Fuel and Oxy-fuel Conditions in a Wall-Fired Utility Boiler

Investigation on the co-combustion characteristics of multiple biomass and coal under O2/CO2 condition and the interaction between different biomass.

Design and operation of a MSW and straw Co-firing CFB boiler