Abstract:Increasing demands for high-performance screw pumps in oil and gas as well as other applications require deep understanding of the fluid flow field inside the machine. Important effects on the performance such as dynamic losses, influence of the leakage gaps and presence and extent of cavitation are difficult to observe by experiments. However, it is possible to study such effects using well-validated computational fluid dynamics models. The novel-structured numerical mesh consisting of a single-computational domain for moving screw pump rotors was developed to allow three-dimensional computational fluid dynamics simulation of such machine possible. Based on finite volume method, the instantaneous mass flow rates, rotor torque, local pressure field, velocity field and other performance indicators including the indicated power were predicted. A calculation model for the bearing friction losses was introduced to account for mechanical losses. The geometry of the inlet and outlet passages and piping system are taken into consideration to evaluate their influences on the pressure distribution and shaft power. The paper also shows the influence of rotor clearances on the pump performance. The computational fluid dynamics model was validated by comparing the numerical results with the measured performance obtained in the experimental test rig through the comprehensive experiment performed for a set of discharge pressures and rotational speeds. Validation includes comparison of mass flow rates, shaft power and efficiency under variety of speeds and discharge pressure. It has been found that the predicted results match well with the measurements. The results also showed that the radial clearances have larger influence on the mass flow rate than the interlobe clearance. The correct design of the flow passages within the screw pump plays significant role in minimizing required power consumption. The analysis presented in this paper contributes to better understanding of the working process inside the screw pump and offers a good reference to improve design and optimize such machines in terms of clearance selection, shape of the ports, piping system, etc. In future, this model will be used for analysis of cavitating flows and determining performance of other multiphase screw pumps.

Thermodynamic performance simulation of a twin-screw multiphase pump

Theoretical and Experimental Investigation of Pressure Generation within Twin-Screw Pump for Multiphase Transport

Numerical Simulation on Pressure Distribution of Twin-screw Multiphase Pump

Theoretical and experimental study on conveying behavior of a twin-screw multiphase pump

STUDY ON THE WORKING PROCESS OF TWIN- SCREW MULTIPHASE PUMP

Numerical modelling of twin-screw pumps based on computational fluid dynamics

A solution for profile generation in twin-screw multiphase pumps

Profile Generation and Analysis for Twin Screw Multiphase Compressor/Pump

Particle distribution and two-phase flow characteristics of twin-screw pump during solid-liquid transfer

Rotordynamics of a Two-Phase Flow Twin Screw Pump

Experiment and Numerical Study of a New Generation Three-Stage Multiphase Pump

Numerical Simulation of the Working Process in the Twin Screw Vacuum Pump

Numerical Simulation on Internal Flow in the Screw Centrifugal Pulp Pump

Study of A Screw Rotor with Different Stocks and Leads for A Twin-Screw Multiphase Pump

Experimental Study on Pumping Behavior of Twin-Screw Multiphase Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Theoretical and Experimental Performance Analysis of a Synchronal Rotary Multiphase Pump with the Inlet Gas Volume Fractions of 0–0.9

Study on the Performance Prediction of Dry Twin Screw Vacuum Pump

Performance analysis of embedded tri-screw pump based on computational fluid dynamics