Abstract:We present a neural stimulator chip with an output stage (electrode driving circuit) that is fail-safe under single-fault conditions without the need for off-chip blocking-capacitors. To miniaturize the stimulator output stage two novel techniques are introduced. The first technique is a new current generator circuit reducing to a single step the translation of the digital input bits into the stimulus current, thus minimizing silicon area and power consumption compared to previous works. The current generator uses voltage-controlled resistors implemented by MOS transistors in the deep triode region. The second technique is a new stimulator output stage circuit with blocking-capacitor safety protection using a high-frequency current-switching (HFCS) technique. Unlike conventional stimulator output stage circuits for implantable functional electrical stimulation (FES) systems which require blocking-capacitors in the microfarad range, our proposed approach allows capacitance reduction to the picofarad range, thus the blocking-capacitors can be integrated on-chip. The prototype four-channel neural stimulator chip was fabricated in XFAB's 1-mum silicon-on-insulator CMOS technology and can operate from a power supply between 5-18 V. The stimulus current is generated by active charging and passive discharging. We obtained recordings of action potentials and a strength-duration curve from the sciatic nerve of a frog with the stimulator chip which demonstrate the HFCS technique. The average power consumption for a typical 1-mA 20-Hz single-channel stimulation using a book electrode, is 200 muW from a 6 V power supply. The silicon area occupation is 0.38 mm(2) per channel.

Neural Signal Rebuilding Microelectronics System with Voltage Function Electrical Stimulation Signal Generator

Function Electrical Stimulation Circuit for Neural Signal Regeneration System

Microelectronics neural bridge IC with voltage stimulation.

Low-Power CMOS IC for Function Electrical Stimulation of Nerves

IC for neural signal regeneration

Design of special microelectronic system chip for neural signal regeneration

Design and experiment of a neural signal detection using a FES driving system

Multi-channel Neural Signal Stimulating Module and In-Vivo Experiments

Integrated circuit for single channel neural signal regeneration

A Four-Channel Microelectronic System for Neural Signal Regeneration

Design and Implementation of Implanted Neural Prosthesis Stimulator

An Energy-Efficient Implantable-Neural-Stimulator System with Wireless Charging and Dynamic Voltage Output.

An Integrated Implantable Stimulator That is Fail-Safe Without Off-Chip Blocking-Capacitors

A High-Voltage, Energy-Efficient, 4-Electrode Output Stage for Implantable Neural Stimulator

Neural Function Rebuilding on Different Bodies Using Microelectronic Neural Bridge Technique

Design of Low-Power Fully Integrated Microelectronic Neural Bridge Chip

A Programmable and Implantable Neuro-stimulator

A Power-Efficient Current-Mode Neural/Muscular Stimulator Design For Peripheral Nerve Prosthesis

Design and Experiment of Wireless Power Supply Module for in Vivo Neural Bridging Chip

Design of a rail-to-rail operational amplifier for implantable neural signal regeneration systems

Biofeedback electrostimulation for bionic and long-lasting neural modulation