Abstract:Cu(2-x)S (x = 1, 0.2, 0.03) nanocrystals were synthesized with three different chemical methods: sonoelectrochemical, hydrothermal, and solventless thermolysis methods in order to compare their common optical and structural properties. The compositions of the Cu(2-x)S nanocrystals were varied from CuS (covellite) to Cu(1.97)S (djurleite) through adjusting the reduction potential in the sonoelectrochemical method, adjusting the pH value in the hydrothermal method and by choosing different precursor pretreatments in the solventless thermolysis approach, respectively. The crystallinity and morphology of the products were characterized by X-ray diffraction (XRD) and transmission electron microscopy (TEM), which shows that most of them might be of pure stoichiometries but some of them are mixtures. The obtained XRDs were studied in comparison to the XRD patterns of previously reported Cu(2-x)S. We found consistently that under ambient conditions the copper deficient Cu(1.97)S (djurleite) is more stable than Cu(2)S (chalcocite). Corroborated by recent computational studies by Lambrecht et al. and experimental work by Alivisatos et al. This may be the reason behind the traditionally known instability of the bulk Cu(2)S/CdS interface. Both Cu(2)S and the copper-deficient Cu(1.97)S have very similar but distinguishable electronic and crystal structure. The optical properties of these Cu(2-x)S NCs were characterized by UV-vis spectroscopy and NIR. All presented Cu(2-x)S NCs show a blue shift in the band gap absorption compared to bulk Cu(2-x)S. Moreover the spectra of these Cu(2-x)S NCs indicate direct band gap character based on their oscillator strengths, different from previously reported experimental results. The NIR spectra of these Cu(2-x)S NCs show a carrier concentration dependent plasmonic absorption.

Hydrothermal synthesis and optical properties of CuS nanoplates

Mild hydrothermal synthesis of hexagonal CuS nanoplates

Synthesis and Optical Properties of CuS Nanoplate-Based Architectures by a Solvothermal Method

Formation Of Single-Crystalline Cus Nanoplates Vertically Standing On Flat Substrate

A Facile Solution Route to CuS Hexagonal Nanoplatelets

Preparation of CdS Nanoparticles by Hydrothermal Method in Microemulsion

Facile synthesis of CuSe nanoparticles and high-quality single-crystal two-dimensional hexagonal nanoplatelets with tunable near-infrared optical absorption

Plasmonic Cu(2-x)S Nanocrystals: Optical and Structural Properties of Copper-Deficient Copper(i) Sulfides.

Synthesis of CdS nanoplates by PAA-assisted hydrothermal approach

Studies of synthesis and optical properties of ZnS nanocrystals

Facile one-pot synthesis of polytypic CuGaS 2 nanoplates

Large-scale synthesis of single-crystalline CuO nanoplatelets by a hydrothermal process

Phase-Selective Synthesis and Self-Assembly of Monodisperse Copper Sulfide Nanocrystals

Controllable Synthesis, Optical and Photocatalytic Properties of Cus Nanomaterials with Hierarchical Structures

Controllable Transformation from Rhombohedral Cu1.8S Nanocrystals to Hexagonal CuS Clusters: Phase- and Composition-Dependent Plasmonic Properties

Solvothermal Synthesis of Copper Sulfide Semiconductor Micro/nanostructures

Synthesis and Visible‐Light Photocatalytic Performance of Cadmium Sulfide and Oxide Hexagonal Nanoplates

Hydrothermal Fabrication of Copper Sulfide Nanocones and Nanobelts

Controllable hydrothermal synthesis of Cu2S nanowires on the copper substrate

Colloidal Synthesis of Cu2SxSe1–x Hexagonal Nanoplates and Their Transformation to CdSxSe1–x and ZnSxSe1–x by the Cation‐Exchange Reaction

CTAB Assisted Synthesis of CuS Microcrystals: Synthesis, Mechanism, and Electrical Properties