Abstract:The primary objective of this study is to investigate the potential of using microscopic simulation models and Surrogate Safety Assessment Model (SSAM) for evaluating the safety performance of signalized intersections. A widely used microscopic simulation package VISSIM was used in this study to develop simulation models. The validity of using VISSIM and SSAM for traffic safety analysis at signalized intersections was tested by comparing the simulated conflicts to those measured in the field using traditional traffic conflicts techniques. Of particular interest was to identify if the consistency between simulated and observed conflicts could be improved by calibrating VISSIM simulation models and adjusting threshold values used for defining simulated conflicts in SSAM. A two-stage procedure was proposed in this study to develop, calibrate and validate VISSIM simulation models. It was found that the two-stage calibration procedure greatly improved the goodness-of-fit between simulated conflicts and real-world conflicts. After model calibration, the mean absolute percent error (MAPE) for total conflicts was reduced from 44% to 24%. More specifically, the MAPE value was reduced from 26% to 15% for rear-end conflicts, from 69% to 29% for crossing conflicts, and from 83% to 81% for lane-change conflicts. Linear regression models and the spearman rank correlation coefficient were also developed to study the relationship between simulated conflicts and observed conflicts. Data analysis results showed that there was a reasonable goodness-of-fit between simulated and observed rear-end and crossing conflicts. However, it was also found that the simulated conflicts generated by VISSIM and SSAM are not good indicators for traffic conflicts which are generated by unexpected driving maneuvers such as illegal lane-changes in the real world.

Application of Microscopic Traffic Simulation

Based on Simulation Method for Solving Traffic Jam Problems.

Developing a 24-Hour Large-Scale Microscopic Traffic Simulation Model for the Before-and-After Study of a New Tolled Freeway in the Washington, DC–Baltimore Region

Identity Microscopic Parameters Calibration of Microscopic Traffic Simulation Models

Freeway Traffic State Estimation Using Fixed and Mobile Sensing Data with Microscopic Simulation Evaluation

Motorway Traffic Surveillance and Control

Capacity Drop at Freeway Ramp Merges with Its Replication in Macroscopic and Microscopic Traffic Simulations: A Tutorial Report

A New United Microcosmic Model of Urban Mixed Traffic Flow

Traffic Simulation with METANET

Enhancing parameter calibration for micro-simulation models: investigating improvement methods

Discrimination model for macroscopic traffic conditions of urban networks using two-fluid theory

Calibrating microscopic traffic models with macroscopic data

Research Of Urban Microscopic Traffic Simulation System

Calibration method for microscopic traffic simulation considering lane difference

Global sensitivity analysis of VISSIM parameters for project-level traffic emissions: a case study at a signalized intersection

Urban Microscopic Traffic Simulation System and Its Application

The Implementation of Microscopic Simulation System of Urban Traffic

Comparative study on simulation performances of CORSIM and VISSIM for urban street network.

Macroscopic Traffic Flow Modelling of Large-Scale Freeway Networks with Field Data Verification: State-of-the-art Review, Benchmarking Framework, and Case Studies Using METANET

GIS Applied in Urban Traffic Micro-Simulation Software

Development of a Procedure for Using Surrogate Safety Assessment Model and VISSIM for Safety Assessment at Signalized Intersections