Abstract:Astrophysical black hole candidates are thought to be the Kerr black hole predicted by General Relativity. However, in order to confirm the Kerr-nature of these objects, we need to probe the geometry of the space-time around them and check that observations are consistent with the predictions of the Kerr metric. That can be achieved, for instance, by studying the properties of the electromagnetic radiation emitted by the gas in the accretion disk. The high-frequency quasi-periodic oscillations observed in the X-ray flux of some stellar-mass black hole candidates might do the job. As the frequencies of these oscillations depend only very weakly on the observed X-ray flux, it is thought they are mainly determined by the metric of the space-time. In this paper, I consider the resonance models proposed by Abramowicz and Kluzniak and I extend previous results to the case of non-Kerr space-times. The emerging picture is more complicated than the one around a Kerr black hole and there is a larger number of possible combinations between different modes. I then compare the bounds inferred from the twin peak high-frequency quasi-periodic oscillations observed in three micro-quasars (GRO J1655-40, XTE J1550-564, and GRS 1915+105) with the measurements from the continuum-fitting method of the same objects. For Kerr black holes, the two approaches do not provide consistent results. In a non-Kerr geometry, this conflict may be solved if the observed quasi-periodic oscillations are produced by the resonance nu(theta) : nu(r) = 3 : 1, where nu(theta) and nu(r) are the two epicyclic frequencies. It is at least worth mentioning that the deformation from the Kerr solution required by observations would be consistent with the one suggested in another recent work discussing the possibility that steady jets are powered by the spin of these compact objects.

CONSTRAINING THE QUADRUPOLE MOMENT OF STELLAR-MASS BLACK HOLE CANDIDATES WITH THE CONTINUUM FITTING METHOD

Constraints on the Spacetime Geometry Around 10 Stellar-Mass Black Hole Candidates from the Disk's Thermal Spectrum

Constraint on the Quadrupole Moment of Super-Massive Black Hole Candidates from the Estimate of the Mean Radiative Efficiency of AGN

X-ray Spectropolarimetric Measurements of the Kerr Metric

Testing the Kerr-nature of Stellar-Mass Black Hole Candidates by Combining the Continuum-Fitting Method and the Power Estimate of Transient Ballistic Jets

Evolution of the Spin Parameter of Accreting Compact Objects with Non-Kerr Quadrupole Moment

Constraining the Spin and the Deformation Parameters from the Black Hole Shadow

Measuring the Kerr Spin Parameter of Regular Black Holes from Their Shadow

Testing a Class of Non-Kerr Metrics with Hot Spots Orbiting SgrA^*

Testing the Existence of Regions of Stable Orbits at Small Radii Around Black Hole Candidates

Super-spinning Compact Objects Generated by Thick Accretion Disks

Testing the Kerr Paradigm with X-ray Observations

Probing the Space-Time Geometry Around Black Hole Candidates with the Resonance Models for High-Frequency QPOs and Comparison with the Continuum-Fitting Method

Testing the Space-Time Geometry Around Black Hole Candidates with the Available Radio and X-ray Data

Constraining the Konoplya-Rezzolla-Zhidenko Deformation Parameters. II. Limits from Stellar-Mass Black Hole X-Ray Data

Probing the Spin-Induced Quadrupole Moment of Massive Black Holes with the Inspiral of Binary Black Holes

On Testing the Kerr Metric of the Massive Black Hole in the Galactic Center via Stellar Orbital Motion: Full General Relativistic Treatment

Testing the Kerr Black Hole Hypothesis with GRS 1716-249 by Combining the Continuum Fitting and the Iron-line Methods

Testing Black Hole Candidates with Electromagnetic Radiation

Constraining the Konoplya-Rezzolla-Zhidenko Deformation Parameters III: Limits from Stellar-Mass Black Holes Using Gravitational-Wave Observations

Testing Conformal Gravity with Astrophysical Black Holes