Abstract:Active sites and structure–activity relationships for methanol synthesis from a stoichiometric mixture of CO2 and H2 were investigated for a series of coprecipitated Cu-based catalysts with temperature-programmed reduction (TPR), X-ray diffraction (XRD), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), and N2O decomposition. Experiments in a reaction chamber attached to an XPS instrument show that metallic Cu exists on the surface of both reduced and spent catalysts and there is no evidence of monovalent Cu+ species. This finding provides reassurance regarding the active oxidation state of Cu in methanol synthesis catalysts because it is observed with 6 compositions possessing different metal oxide additives, Cu particle sizes, and varying degrees of ZnO crystallinity. Smaller Cu particles demonstrate larger turnover frequencies (TOF) for methanol formation, confirming the structure sensitivity of this reaction. No correlation between TOF and lattice strain in Cu crystallites is observed suggesting this structural parameter is not responsible for the activity. Moreover, changes in the observed rates may be ascribed to relative distribution of different Cu facets as more open and low-index surfaces are present on the catalysts containing small Cu particles and amorphous or well-dispersed ZnO. In general, the activity of these systems results from large Cu surface area, high Cu dispersion, and synergistic interactions between Cu and metal oxide support components, illustrating that these are key parameters for developing fundamental mechanistic insight into the performance of Cu-based methanol synthesis catalysts.

Copper crystallite size and methanol synthesis catalytic property of Cu-based catalysts promoted by Al, Zr and Mn

Strong Cu/ZnO Interfacial Interaction Induced by ZrO2 Promoter Suppressing the Ethanol Formation in Industrial Methanol Synthesis

Preparation of Cu-based Catalysts for Methanol Synthesis in a Fluidized Bed Reactor and Their Performance

Comparative studies of manganese-doped copper-based catalysts: the promoter effect of Mn on methanol synthesis

Structure and Catalytic Performance of Mn- and La-Modified Cu/Zro2 Catalysts for Methanol Synthesis

Cu-Zr-Zn catalysts for methanol synthesis in a fluidized bed reactor

Preparation of CuO/ZnO/Al2O3 Catalysts for Methanol Synthesis Using Parallel-Slurry-mixing Method

Performance of Cu-Mn-Zn/ZrO2 catalysts for methanol synthesis from CO2 hydrogenation: The effect of Zn content

Size Effect of Cu Particles on Interface Formation in Cu/ZnO Catalysts for Methanol Synthesis

Surface Properties of CuO/ZnO/Al_2O_3 Catalyst for Methanol Synthesis in Slurry Reactor

Active Sites and Structure–Activity Relationships of Copper-Based Catalysts for Carbon Dioxide Hydrogenation to Methanol

Promoting effect of an aluminum emulsion on catalytic performance of Cu-based catalysts for methanol synthesis from syngas

XPS Studies of Cu/ZnO/Al2O3 Ultra-Fine Catalysts Derived by a Novel Gel Oxalate Co-Precipitation for Methanol Synthesis by CO2+H2

Effect of Cu and Zn on the performance of Cu-Mn-Zn/ZrO2 catalysts for CO2 hydrogenation to methanol

Synthesis of a Cu@ZnO1-x/Al2O3 Catalyst with High-Density ZnO1-x-Cu Interfacial Sites for Enhanced CO2 Hydrogenation to Methanol

Computational exploration of sub-nano Zn and Cu species on Cu/ZrO2: Implications for Methanol synthesis

Dynamic Transformation of Active Components in Cu-ZnO-Al_2O_3 Catalyst for Methanol Synthesis at High Temperature

High-Performance Cu/ZnO/Al 2 O 3 Catalysts for CO 2 Hydrogenation to Methanol

Optimizing Methanol Synthesis from CO2 Hydrogenation over Inverse Zr-Cu Catalyst

Development of highly stable catalyst for methanol synthesis from carbon dioxide

Methanol Synthesis from CO2 Hydrogenation with a Cu/Zn/Al/Zr Fibrous Catalyst