EFFECT OF NP SUPPLY ON HERB YIELD, HYPERICIN CONTENT AND CADMIUM ACCUMULATION OF St. JOHN\'S WORT (HYPERICUM PERFORATUM L.)
M. Azizi,R. Omidbaigi
DOI: https://doi.org/10.17660/ACTAHORTIC.2002.576.39
2002-04-01
Abstract:The experiment was done on `Topas` cultivar in the Research Station of Tarbiat Modarres University located near Tehran and was conducted through two successive seasons of 1998-1999. We have studied the effect of three levels of nitrogen fertiliser (0, 150, 250 kg ha) and three levels of phosphorous fertiliser (0, 100, 200 kg ha) on herb yield, hypericin content and cadmium accumulation of the plant. Results show that fertiliser treatments can affect herb quality and yield. The highest herb yield (1053.9 g m) was produced in the plots that received 250 kg N and 100 kg P fertiliser as compared to control plot(745.8 g m). According to the results NP-supply increased the number of flowering stems per plant and hypericin content. There is a significant correlation between the number of flowering stems and the hypericin content of the St. John’s wort herb. All fertiliser treatments increased cadmium accumulation of the herb as compared to the control treatment. The highest cadmium content (0.269 mg kg dry weight basis) was measured in the plot that received 250 kg N and 200 kg P fertiliser, the lowest cadmium content was measured (0.091 mg kg dry weight basis) in the control plot. INTRODUCTION St. John’s wort (Hypericum perforatum L.) is an important medicinal plant that has been used since ancient for pharmaceutical effects such as wound healing and antidepressive properties (Hungarian Pharmacopoeia, 1984, Bombardelli and Morazzoni, 1995, Cellarova et al., 1995). Hypericin, a polycyclic aromatic dione, is one of the most important secondary metabolites. It shows antiviral and antiretroviral activities (ESCOP, 1996, Cellarova et al., 1995). The formation and accumulation of active substances in medicinal plants are affected by environmental condition (Franz 1983, Palevitch, 1987. Edaphic factors especially chemical properties of the soil also have particular importance in the development of active substances (Franz, 1983). Hypericum perforatum is a cadmium accumulator (Marquard and Schneide, 1996, Buter et al., 1996), nitrogen and phosphorus fertilisers affect cadmium accumulation in plants (Grant et al., 1998), therefore we studied the effects of NP-supply on active substances and cadmium accumulation in the plant. MATERIALS AND METHODS Field Experiment Seeds of Hypericum perforatum L. cultivar `Topas` were soaked in water overnight, dried, and were sown at a depth of 5 mm in spring in the open field nursery and irrigated afterwards regularly. When the seedlings reached the 25 cm height, they were transplanted into the field for fertiliser treatments. Each plot was 125×160 cm in size and 40 cm x 25 cm plant spacing was applied. Three levels of nitrogen (0, 150, 250 kg ha) and three levels of phosphorus (0, 100, 200 kg ha) were provided. Sources of N and P fertilisers were urea and super phosphate. The P fertiliser contained an average of 26 mg Cd kg. Proc. Int. Conf. on MAP Eds. J. Bernáth et al. Acta Hort. 576, ISHS 2002 268 Hypericin Analysis One gram of air-dried and homogenised aerial part of Hypericum perforatum was extracted in a Soxhlet with chloroform (200 ml) until chlorophyll ceased extracting (4 h). During this period the temperature of water bath was 70 oC. After removal of chloroform the thimble was reextracted with acetone (200 ml) until the red pigment, hypericin, ceased extracting (6 h). The water bath temperature was 65 oC. The filtrate allowed to evaporate in a rotary evaporator and the water bath temperature was set at 35 oC. This was followed by addition of methanol to make up 25 ml. The mixture was then mixed and filtered, supernatant was then discarded and 5 ml of the mixture were diluteded with 20 ml of methanol. The methanolic extract was then analysed by spectrophotometer (Unicam 8700 series U.V. visible) at 590 nm (Upton, 1997), and the hypericin content was calculated by the following equation (Anounymus, 1991, Upton, 1997): A × h × 1000 H = -----------------------------B × 718 × (100 – a) H : Hypericin content (μg g); A : Absorbance at 590 nm; h : Dilution parameter (125) ; B : Diameter of Cuvette (1 cm); 718 : Specific absorbance of hypericin; a: Sample moisture content. Cadmium Analysis The cadmium content of the samples was determined according to the LUFAmethod introduced for the analysis of animal food products (Anonymous, 1988). The dried samples were ashed at 550 oC by dissolving the tissue in 20 % HNO3. Cadmium concentration was measured using Varian 300/400 atomic absorption spectrophotometer at a wavelength of 228.8 nm using a graphite furnace with deuterium correction.
Biology,Agricultural and Food Sciences