Abstract:Fully developed turbulent pipe flow at Re=11300 as well as Re=5300 is measured by PIV using water as working fluid. Excellent agreement with DNS (Direct Numerical Simulation) by Satake (2000) is achieved by choosing optimum measurement parameters such as spatial resolution, time separation of two images, and number of samples. The test section is 6.7m long stainless steel pipe with transparent PIV measurement section attached seamlessly at the end. The measurement section consists of transparent acrylic circular pipe of 1mm thick and water jacket with square cross section. The water jacket reduces the image distortion due to the pipe curvature in almost entire area of the pipe cross section to negligible level except for the region very close to the pipe wall. For turbulent flow measurement using PIV, the requirement for spatial resolution is very severe in order to resolve the fluctuating velocity field especially at high Reynolds number. Therefore, higher magnification is chosen at the cost of the size of measurement area to assure enough spatial resolution. Consequently, the size of the measurement area is half of the pipe radius and measurement is performed at two regions which are called near-wall region and pipe center. For image analysis, the iterative multi-step cross-correlation algorithm with spatio-temporal gradient method for subpixel refinement is used. Detail of the algorithm can be found in Scarano (1999) and Sugii (2000). The smallest interrogation window is 8x16 pixels which corresponds to 249 x 585μm. The near-wall structure is observed from vector map of fluctuating in-plane velocity components and out-of-plane component of vorticity fluctuation. The shear layer structure is clearly shown by vorticity fluctuation and ejection and sweep motion is also observed. The mean velocity profile and statistics are calculated from 4000 samples of vector map by first taking temporal statistics and then spatial average along streamwise direction and compared with DNS in non-dimensional form using friction velocity. Since accurate measurement of friction velocity is essential for the comparison with DNS, using pressure gradient is not appropriate due to the relatively small pressure drop along the pipe. Therefore, curve-fitting method using near-wall turbulent model developed by McEligot (1984) is applied to calculate friction velocity from the velocity profile in buffer region.

An experimented study on the flow characteristics in a three-dimensional cylindrical branching channel

Flow Characteristics in a Three‐dimensional Cylindrical Branching Channel

Flow Pattern Variations of Viscoelastic Fluid Flows in Three‐dimensional Branching Channel

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

Numerical Research on the Fiber Suspensions in a Turbulent T-shaped Branching Channel Flow

Numerical Simulation of Laminar Flow in Various Curved Pipes Using a Boundary-Fitted Coordinate System.

Three-Dimensional Flow Around Two Tandem Circular Cylinders with Various Spacing at Re=220

Numerical Computations of the Flow in A Finite Diverging Channel

Multi-dimensional Characteristics of Upward Bubbly Flows in a Vertical Large-Size Square Channel

Numerical simulation for various curved pipes using a boundary-fitted coordinate system.

Direct Numerical Simulation of A High-Froude-Number Turbulent Open-Channel Flow

Three-dimensional Numerical Simulation on Flow Past Three Circular Cylinders in an Equilateral-Triangular Arrangement

Experimental and Numerical Flow Visualizations of Mixed Convection with Flow Reversal in a Horizontal Channel with Constant Wall Temperature

WALL EFFECTS ON FLOWS PAST TWO TANDEM CYLINDERS OF DIFFERENT DIAMETERS

Experimental Investigation on Flow Past Nine Cylinders in a Square Configuration

Numerical Prediction of Fiber Motion in A Branching Channel Flow of Fiber Suspensions

Exploring fluid flow in microchannels with branching and variable constrictions

Measurements of turbulence statistics and near-wall structure of fully developed pipe flow at high Reynolds number

Simulation of flow around two rotating cylinders in a side-by-side arrangement at long channel using LB-DF/FD method

Observation of Flow Around a Vertical Cylinder in a Parallel Channel.

Three-Dimensional Flow Around Two Circular Cylinders in Tandem Arrangement