Abstract:With advanced digital technologies as the key support, many scholars and researchers have proposed various random warranty models by integrating mission cycles into the warranty stage. However, these existing warranty models are designed only from the manufacturer's subjective perspective, ignoring certain consumer requirements. For instance, they overlook a wide range of warranty coverage, the pursuit of reliability improvement rather than mere minimal repair, and the need to limit the delay in repair. To address these consumer requirements, this paper proposes a novel random collaborative preventive maintenance warranty with repair-time threshold (RCPMW-RTT). This model incorporates terms that are jointly designed by manufacturers and consumers to meet specific consumer needs, thereby overcoming the limitations of existing warranty models. The introduction of a repair-time threshold aims to limit the time delay in repairing failures and to compensate for any losses incurred by consumers. Using probability theory, the RCPMW-RTT is evaluated in terms of cost and time, and relevant variants are derived by analyzing key parameters. As an exemplary representation of the RCPMW-RTT, two random replacement policies named the discrete random renewable back replacement (DRRBR) and the discrete random renewable front replacement (DRRFR) are proposed and modelled to ensure reliability after the expiration of the RCPMW-RTT. In both policies, product replacement is triggered either by the occurrence of the first extreme mission cycle or by reaching the limit on the number of non-extreme mission cycles, whichever comes first. Probability theory is used to present cost rates for both policies in order to determine optimal values for decision variables. Finally, numerical analysis is performed on the RCPMW-RTT to reveal hidden variation tendencies and mechanisms; numerical analysis is also performed on the DRRBR and the DRRFR. The numerical results show that the proposed random replacement policies are feasible and unique; the replacement time within the post-warranty coverage increases as the maintenance quality improves and the cost rate can be reduced by setting a smaller repair-time threshold.

Optimum Ordering Policy for Preventive Age Replacement

A condition-based order-replacement policy for a single-unit system

An Optimum Condition-Based Replacement And Spare Provisioning Policy Based On Markov Chains

A Condition-Based Replacement and Spare Provisioning Policy for Deteriorating Systems with Uncertain Deterioration to Failure.

Ordering Policies for Periodic-Review Inventory Systems with Quantity-Dependent Fixed Costs

Preventive Repair Policy and Replacement Policy of Repairable System Taking Non-Zero Preventive Repair Time

Joint Optimization of Preventive Replacement and Spare Part Ordering for Single‐Unit Systems With Mixed Inspections

Approximation Approaches for Inventory Systems with General Production/Ordering Cost Structures

Analysis of batch ordering inventory models with setup cost and capacity constraint

Joint Optimization Of Preventive Replacement And Periodic Review Spare Part Provisioning Policy With Used Items

A generalized age-dependent minimal repair with random working times

Optimal Replacement Policy for Safety-Related Multi-Component Multi-State Systems.

A Receding Optimization Control Policy for Production Systems with Quadratic Inventory Costs

Calendar-time-based and age-based maintenance policies with different repair assumptions

Preventive Replacement Policies of Parallel/Series Systems with Dependent Components under Deviation Costs

Discrete Random Renewable Replacements after the Expiration of Collaborative Preventive Maintenance Warranty

Joint optimization of condition-based and age-based replacement policy and inventory policy for a two-unit series system

Predictive Condition-based Replacement and Spare Ordering Policy for Dynamic Systems Suffering Hidden Degradatio

Managing Perishable Inventory Systems with Age-differentiated Demand

Optimization of a preventive maintenance strategy for a product with limited repair times

Optimal maintenance policy for a k-out-of-n system with replacement first and last