Abstract:Large volume cubic press is one of the most popular high pressure devices which can produce pressures up to about 7 GPa. It is well known experimentally that the enhancing of the maximum pressure generated in the large volume cubic press has attracted wide attention among scientists and engineers because the higher pressure is capable of synthesizing some materials with interesting properties. In the large volume cubic press, pyrophyllite is typically used as a pressure-transmitting medium. A specimen immersed in such a solid experiences a generalized stress state. The pressure distribution in pyrophyllite is an important parameter for characterizing the sample environment and designing the experiments at high pressure. There is a need for the quantitative measurement of pressure gradients in the pyrophyllite pressure medium, so that the accurate experimental data under high pressure can be obtained. In the large volume cubic apparatus (68 MN), we put a circuit into the high pressure cubic cell, so that the pressures at various positions can be measured by using the phase transitions in Bi, Tl and Ba. In the present work, the relationship between the total press load and the press load allocated to the anvil face, and the relationship between the total press load and the press load allocated to gaskets are established at room temperature. The results show that with the increase of the total press load, the load allocated to the gaskets is increased sharply, while the curve of load allocated to the anvil face versus total press load reaches a plateau, which results in the cell pressure reaching upper limit when the cell pressure reaches up to about 5 GPa. According to the experimental results, the stress state of the cubic cell under high pressure is analyzed and the reason why the pressure generated in the large volume cubic chamber is difficult to exceed 7 GPa is explained. Based on the geometrical structure of the cubic cell, the scheme to increase the upper pressure limit for cubic cell by using the material with high bulk modulus as the pressure transmitting medium and the material with low bulk modulus as the gasket, is proposed. Additionally, the method of calculating the pressure values at different positions along the axis of symmetry in the cubic cell is given through the quantitative calibration of the pressure gradient in the axial direction of the cubic cell. This method can provide more accurate pressure data for high pressure experiments.

High-pressure study on lead fluorapatite

Structural Change in Lead Fluorapatite at High Pressure

Synthetic Lead Bromapatite: X-ray Structure at Ambient Pressure and Compressibility Up to about 20 GPa

Solid solutions between lead fluorapatite and lead fluorvanadate apatite: compressibility determined by using a diamond-anvil cell coupled with synchrotron X-ray diffraction

Force Analysis and Pressure Quantitative Measurement for the High Pressure Cubic Cell

Pressure-induced Phase Transition of Lead Phosphate Pb3(PO4)2: X-ray Diffraction and XANES

Expansivity and Compressibility of Strontium Fluorapatite and Barium Fluorapatite Determined by in Situ X-ray Diffraction at High-T/p Conditions: Significance of the M-site Cations

Synthesis of a new potassium-substituted lead fluorapatite and its structural characterization

Electrical Conductivity of K-feldspar at High Temperature and High Pressure

High Pressure Experimental Studies on Na3Fe(PO4)(CO3) and Na3Mn(PO4)(CO3): Extensive Pressure Behaviors of Carbonophosphates Family

Characterization, dissolution and solubility of lead fluorapatite at 25-45 °C

First Principles NMR Study of Fluorapatite under Pressure

Lead: X-ray Diffraction Study of a High-Pressure Polymorph.

In situ synchrotron X-ray diffraction with laser-heated diamond anvil cells study of Pt up to 95 GPa and 3150 K

X-ray diffraction study of β-Ca3(PO4)2 at high pressure

Phase Transition and Compression Behavior of Gibbsite under High-Pressure

Strength and Equation of State of Fluorite Phase Ceo2 under High Pressure

In-situ Raman study and phase transition of gypsum under high pressure

Structure evolution of hydroxyapophyllite-(K) under high pressure

High-pressure phase transition and equation of state of lead to 238 GPa

High-pressure investigation on prehnite: X-ray diffraction and Raman spectroscopy