Abstract:In the traditional load model, motor and static loads are used to represent electrical equipment. However, since the electrical equipment using power electronic interface has accounted for a large proportion at present, the load components should be divided into motor, static load and power-electronic-interfaced load. The composition of the electric load is time-varying, and mastering the proportion of different load components is the key to establish an accurate load model. The existing load component proportion identification method identifies the key parameters of the load model and motor proportion parameters under large disturbances. However, the accuracy of this method is affected by the accuracy of load model parameters; moreover, it cannot identify the proportion of three types of load components. To this end, based on the analysis of different response characteristics of motor, static load and power-electronic-interfaced load under large disturbance, this paper proposes a load component proportion identification method based on dynamic response under large disturbance. This method first determines the proportion of static load according to the drop value of active power of load during the duration of large disturbance; then, the proportion of power-electronic-interfaced load is determined according to the separation results of motor response and the highest fitting accuracy; finally, the proportion of motor load can be calculated. The case study shows that the method does not depend on other parameters in the load model and has high identification accuracy.

Electrical Dynamic Load Modeling Based on the Power Quality Equipments Data and the Improved Clone Selection Algorithm

A new generalized load model of power systems and its applications

Online Synthetic Load Modeling System for Fujian Power Grid

Component Based On-line Modeling for Electric Loads

Modeling Methods for Electric Loads in a Real Power Grid

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Load Modeling with Considering Frequency Characteristic

New method for on-line modelling of electric loads

Research on Dynamic Load Modelling Based on Power Quality Monitoring System

Load Modeling for Wide Area Power System

Electric Load Modeling for Wide Area Power Systems

Load Clustering and Synthetic Modeling Based on Daily Load Curves

Load Modeling Including Air Conditioners

Identification Method of the Load Component Proportion Based on the Dynamic Response under Large Disturbance

Generalized Load Modeling of Distribution Network Integrated with Direct-drive Permanent-magnet Wind Farms

Improvements and measurements of parameter identification for electric load

Further Research on Load Modeling and Parameter Identification based on Online Measured Data

Simplified Modeling of the Power-electronized Load Based on Sensitivity Analysis

Construction and Verification of the BPA-Based Practical Load Model of Guangdong Power Grid

New Load Modeling Approach During Asymmetric Disturbance and Its Engineering Application

Comprehensive Load Model Improving and Prediction Identification Software Design for Sichuan Power Grid