Abstract:To investigate the possibility of engineering a glycocalyx-like surface via end-tethered hydrophobic ligand onto poly(ethylene oxide) (PEO), polystyrene-graft-[omega-stearyl-poly(ethylene oxide)] (PS-g-SPEO), which has poly(styrene) backbone and PEO side chains end-functionalized with stearyl groups, was specifically prepared. X-ray photoelectron spectroscopy results indicated that SPEO was enriched at the surface. Differential scanning calorimetry results revealed that the stearyl end groups tended to assemble a stable stearyl phase, which could be destroyed by a thermal treatment. A "looplike" SPEO (sample A) and a "tail-like" SPEO (sample B), which had almost the same surface composition, were then used as model surfaces to study the surface architecture of end-tethered PEO in aqueous environment. The contact angle at the sample A/water interface decreases rapidly with increasing of the water hydration time. After longer water incubation, it presented a hydrophilic interface with the low PEO mobility. Sample A was shown to impart significant resistance to both albumin and fibrinogen adsorption. But it is nonselective for the albumin. By contrast, the contact angle at the sample B/water interface decreases little with water hydration. It presented a hydrophobic interface with the high ethylene oxide mobility. Sample B exhibits a very low fibrinogen adsorption while adsorbing a high level of albumin. All above results proved that sample B may keep a "tail-like" SPEO in aqueous solution and it is possible to get a glycocalyx-mimic surface, in which a hydrophobic matrix was covered by a layer of flexible hydrophilic PEO and then by hydrophobic signal molecules.

A Simple Swelling and Anchoring Method for Preparing Dense and Stable Poly(ethylene Oxide) Layers on Polystyrene Surfaces

Surface immobilization of polymer brushes onto porous poly(vinylidene fluoride) membrane by electron beam to improve the hydrophilicity and fouling resistance

Ultrahydrophobicity Of Polydimethylsiloxanes-Based Multilayered Thin Films

Nanoporous Films with Superior Resistance to Protein Adsorption by Selective Swelling of Polystyrene-Block-Poly(Ethylene Oxide)

Stable Ph Responsive Layer-by-layer Assemblies of Partially Hydrolysed Poly(2-Ethyl-2-oxazoline) and Poly(acrylic Acid) for Effective Prevention of Protein, Cell and Bacteria Surface Attachment.

Honeycomb-Patterned Films of Polystyrene/Poly(Ethylene Glycol): Preparation, Surface Aggregation and Protein Adsorption

Hydrogen-Bonding-Driven Complexation of Polystyrene-Block-Poly(Ethylene Oxide) Micelles with Poly(Acrylic Acid)

Fabrication of Free-Standing Polyelectrolyte Multilayer Films: a Method Using Polysulfobetaine-Containing Films As Sacrificial Layers.

Immobilizing PEO–PPO–PEO Triblock Copolymers on Hydrophobic Surfaces and Its Effect on Protein and Platelet: A Combined Study Using QCM-D and DPI

Preparation of Diazoresin/poly(ethylene Oxide)(x)-B-polystyrene-b-poly(ethylene Oxide)(x) Capillary Coating for Analysis of Proteins by Capillary Electrophoresis

Self-Assembly and Surface Structure of an Amphiphilic Graft Copolymer, Polystyrene-graft-ω-Stearyl–Poly(ethylene oxide)

"Loop" or "tail"? Self-Assembly and Surface Architecture of Polystyrene-Graft-Omega-Stearyl-Poly(Ethylene Oxide)

Adsorption of polypropylene oxide-polyethylene oxide type surfactants at surfaces of pharmaceutical relevant materials: effect of surface energetics and surfactant structures

Studies on protein-resistance of amphiphilic polystyrene-g-poly(ethylene oxide) copolymers

HYDROPHILIC MODIFICATION OF PPESK POROUS MEMBRANES VIA AQUEOUS SURFACE-INITIATED ATOM TRANSFER RADICAL POLYMERIZATION

The histological observations on the large intestine of the goose (Anser anser) during the pre- and post-hatching periods.

Evaporative deposition of polystyrene microparticles on PDMS surface

Surface Modification of Polypropylene by the Entrapping Method Using the Short-Chained Stearyl-Alcohol Poly(Ethylene Oxide) Ether Modifier

Probing surface interactions of underwater oleophobic polyelectrolyte multilayers

Controllable Assembly of Colloid Particles on the Surface of Polyelectrolyte Multilayer Films

Stearyl Poly(ethylene Oxide) Grafted Surfaces for Preferential Adsorption of Albumin