Abstract:The adsorption of emulsifier on latex particle surfaces often determines the stability of the latex. However, relatively few adsorption isotherms have been published because these experiments are difficult and time-consuming. This paper describes the determination of adsorption isotherms using a new serum replacement technique, which was developed to characterize latex particle surfaces by removing adsorbed emulsifier from the latex particle surfaces and solute electrolyte from the aqueous phase. The latex is confined in a cell with a Nuclepore filter membrane, and doubly-distilled, deionized water is pumped through the latex to replace the serum. This method allows complete recovery of the serum, as well as determination of the concentration profile of the desorbing species in the effluent stream. To determine adsorption isotherms, a known amount of emulsifier is added to a cleaned latex and the concentration profile of the emulsifier in the effluent stream is measured. A material balance between added emulsifier and desorbed emulsifier (from the concentration profile) gives the adsorption isotherm. This adsorption isotherm is correlated with the predictions of a mathematical model of the process. The adsorption of technical-grade sodium lauryl sulfate, Aerosol MA, and Aerosol OT on a Dow monodisperse polystyrene latex of 190 nm diameter determined at 23 ± 2° follows a Langmuir adsorption isotherm. The mole-r culaç areas at saturation are 42 - 43 A2 , 39 - 45 A2, and 85 -100 A2, respectively. The adsorption of sodium lauryl sulfate on a monodisperse polymethyl methacrylate latex of 330 nm diameter also follows a Langmuir absorption isotherm and gives a molecular area at saturation of 57 A2. The adsorption of sodium lauryl sulfate on a monodisperse polyvinyl acetate latex of 165 nm diameter does not follow a Langmuir adsorption isotherm, but instead gives a curve characteristic of porous surfaces. The molecular area at saturation is 30 A2.

Dynamic Light Scattering Study of Nonionic Surfactant (C12E25) Adsorption on Polystyrene Latex Particles: Effect of Poly(ethylene Oxide) Chain Size

Dynamic Adsorption and Structure of Interfacial Bilayers Adsorbed from Lipopeptide Surfactants at the Hydrophilic Silicon/water Interface: Effect of the Headgroup Length.

Effect of Oxyethylene Groups of Fatty Alcohol Polyoxyethylene Ether Sodium Sulfates on Equilibrium and Dynamic Surface Tension in Relation to Wetting Properties

Effect of Surfactant Head Group Size on Polyelectrolyte–surfactant Interactions: Steady-State and Time-Resolved Fluorescence Study

Adsorption behavior and application properties of natural alcohol polyoxyethylene polyoxypropylene ether sulfate

Adsorption of extended anionic surfactants at the water- polymethylmethacrylate interface: The effect of polyoxyethylene groups

Study of the Amount of Surfactant in the Core-Shell Emulsion Polymerization

Rapid Measurement of Adsorption Isotherms of Emulsifiers on Latex Particles

Adsorption and Aggregation Behaviors of Oleyl Alcohol-Based Extended Surfactant and Its Mixtures

Adsorption Behavior of Fatty Alcohol Ether Sulfonate at Different Interfaces

Hydrophilic Chain Length for Octylphenol Polyoxyethylene Ether Adsorption at the n -Hexadecane-Water Interface: Theoretical and Experimental Study

Aggregation Behavior of Polyether Based Siloxane Surfactants in Aqueous Solutions: Effect of Alkyl Groups and Steric Hindrance.

The Order of Surface Adsorption and Micella Formation of Binary Surfactant Systems Containing Dodecyl Polyglycoside

Surface Tension, Interfacial Tension and Emulsification of Sodium Dodecyl Sulfate Extended Surfactant

Surface Aggregate Structure of Nonionic Surfactants on Silica Nanoparticles

Temperature Induced Hydrophobic Adsorption and Desorption of Linear Polymer Chains on Surfactant-Free Latex Nanoparticles

C$_\text{n}$TAB/Polystyrene Sulfonate Mixtures at Air-Water Interfaces: Effects of Alkyl Chain Length on Surface Activity and Charging State

Microcalorimetric and SAXS Determination of PEO-SDS Interactions: The Effect of Cosolutes Formed by Ions

Effect of hydrophilic comonomer and surfactant type on the colloidal stability and size distribution of carboxyl- and amino-functionalized polystyrene particles prepared by miniemulsion polymerization.

Effect of inorganic electrolyte concentration on anionic-cationic adsorption films Part 1 . Decylpyridinium chloride + sodium octylsulphonate + sodium chloride

Impact of Degree of Ethoxylation on Sodium Lauryl Ether Sulfate Surfactant Adsorption onto Silicone-in-Water Emulsion Droplets