Abstract:Numerical simulation is an important method to study the penetration into targets. Distinct results may be acquired if different kinds of software are adopted. In this paper, three kinds of commonly-used softwares (LS-DYNA, ABAQUS and PAM-CRASH) were adopted to simulate the same series of penetration experiments. The simulation results were analyzed and the advantages and disadvantages of each kind of software were compared. The purpose of this work is to help the researchers and engineers to select the most suitable software. The results in this paper demonstrate that the calculation results of the three kinds of software are basically consistent with the experimental results. The simulation results of the flat-headed projectile are generally better than those of the hemispherical projectile. The residual velocity of the projectile and the plug velocity were simulated well using all of the three kinds of software. The calculated velocities by ABAQUS and PAM-CRASH are closer to the experimental results, and the average relative errors are generally lower than 15%. Moreover, the errors from most calculation results by PAM-CRASH are even less than 10%. However, for the deformation of the projectile, the calculation results of the three kinds of software are quite different from the experimental ones. There are other differences in the performance of the three kinds of software. For example, the ballistic limits calculated by ABAQUS and LS-DYNA are higher than the experimental results, while those by PAM-CRASH are lower. ABAQUS is most likely to report errors but is balanced by calculation time and effects. LS-DYNA has a low error rate and good robustness. The change of model parameters (such as mesh density, friction coefficient, contact stiffness, viscous damping coefficient, etc.) has little effect on its calculation results. PAM-CRASH is greatly affected by model parameters. The conclusion of this paper is based on the following conditions: the target material is Weldox 460E steel, the projectile is ARNE tool steel, and the impact velocity range is 180－450 m/s. However, it is also of guiding significance for the penetration problem simulation of other materials in this velocity range.

On the Effect of Steel Bar Configuration on Projectile Penetration Process

Projectile penetration of reinforced concrete considering the effect of steel reinforcement: Experimental study and theoretical analysis

Resistance Model of Rigid Projectile Penetrating into Reinforced Concrete Target

Experimental and theoretical study on steel long-rod projectile penetration into concrete targets with elevated impact velocities

Experimental and numerical study on projectiles' high-velocity penetration into reinforced concrete

Numerical simulation of high speed penetration into concrete by steel projectiles

A Computational Study on the Overload Characteristic Curves of Projectile Penetrating Metal Object

Comparative study of numerical simulations of projectile penetration into metal targets

Effects of Reinforcement Ratio and Impact Position on Anti-Penetration Properties of Reinforced Concrete

Analysis on Deflection of Projectile Penetrating into Composite Concrete Targets

Experimental Study on Overload Characteristics of Projectile Penetrating Reinforced Concrete

High Velocity Long Rod Projectile's Penetration into Semi-Infinite Concrete Targets

Study on the Behavior of Projectile Shank Friction Penetrating into Concrete

Experimental Studies on Kinetic Projectile's Direct Penetrations with Low-speed Against Reinforced Concrete Targets

Study on Target Structure Equivalent of Kinetic Energy Projectile Penetrating Concrete Target

Numerical Prediction of Projectile Residual Velocity after Penetration of Reinforced Concrete with Different Reinforcing Bar Arrangements

Experiment and simulation for projectile penetrating concrete target with finite thickness

Experimental research on the mechanism of a high-velocity projectile penetrating into a reinforced concrete target

Cylindrical Cavity Expansion Model for Projectile Normally Penetrating into Concrete Target

Experimental and 3D Mesoscopic Numerical Simulation Study of Kinetic Projectile Penetrating into Concrete

Study on Behavior of Semi-Infinite Concrete Targets Subjected to Projectile Normal Penetration