Abstract:Phase change material (PCM) are characterized by their high latent heat and low density. Combining PCM with building walls, aircraft fuselages, and other structures can significantly enhance the thermal sink capability of these structures. In order to address the issue of low heat storage efficiency resulting from the low thermal conductivity of PCM, a novel integrated thermal protection structure (ITPS) architecture with a supportive structure based on a porous lattice has been designed. Experimental and numerical methods were employed to investigate the thermal response characteristics of the ITPS with and without PCM, the melting behavior of PCM within the porous lattice, and the effects of lattice configuration and pore size on the PCM melting rate. The current ITPS study includes evaluation of two types of lattice configurations and three different pore sizes. The results indicate that the inclusion of PCM reduces the internal panel temperature of the ITPS by approximately 15%. The melting of PCM occurs primarily at the central region of the porous lattice and gradually spreads towards the periphery until complete melting is achieved. Specifically, the Gibson–Ashby lattice configuration enhances the PCM melting rate by 43.5%, while the tetradecahedron lattice configuration yields a 53.1% improvement. Furthermore, for PCM with different pore sizes, smaller pores exhibit faster melting rates during the early and intermediate stages, whereas larger pores exhibit faster melting rates in the later stages as the proportion of liquid PCM increases. The conclusions of this study provide valuable insights for the application of PCM in the field of thermal management.

State-of-Arts and Trend of Integrated Thermal Protection Systems

Thermal Protection System Integrating Graded Insulation Materials and Multilayer Ceramic Matrix Composite Cellular Sandwich Panels

Experimental and Numerical Analysis of Integrated Thermal Protection System

Effective Mitigation of the Thermal Short and Expansion Mismatch Effects of an Integrated Thermal Protection System Through Topology Optimization

Coupled ablation and thermal behavior of an all-composite structurally integrated thermal protection system: Fabrication and modeling

Thermomechanical Behaviors of a Novel Double-Layer Corrugated Core Structure for Thermal Protection System

Thermo-mechanical Analysis of a Multilayer Hollow Cylindrical Thermal Protection Structure with Functionally Graded Ultrahigh-Temperature Ceramic to Be Heat Resistant Layer

A Pore Scale Study on Heat Transfer Characteristics of Integrated Thermal Protection Structures with Phase Change Material

Finite Element Analysis of Metallic Thermal Protection Systems Design

Design of Thermal Protection Structures for High Temperature Thermophysical Property Testing System

Study on Edge Heat Shorts of Metallic Thermal Protection Systems

Sandwich panel design and performance optimization based on triply periodic minimal surfaces

Improved Metallic Thermal Protection Systems for Reentry Vehicles: Thermomechanical and Impact Considerations

Structure Redesign of the Integrated Thermal Protection System and Fuzzy Performance Evaluation

Mechanism of Thermomechanical Coupling of High Temperature Heat Pipe Cooled C/C Composite Material Thermal Protection Structure

Finite Element Analysis on Coupling Properties of Ultimate Loading Capacity with Heat Insulation for Wall Panels with Internal Insulation

Steady Heat Transfer Analysis of Multilayer Thermal Insulations for Metallic Thermal Protection System

Mechanical Stability of Hybrid Corrugated Sandwich Plates under Fluid-Structure-Thermal Coupling for Novel Thermal Protection Systems

Modeling the high temperature behavior of all-composite, corrugated-core sandwich panels undergoing ablation

Experimental investigation of bolt loosening detection in thermal protection panels at high temperature

Multi-Scale Structural Design and Advanced Materials for Thermal Barrier Coatings with High Thermal Insulation: A Review