Abstract:Ni-based catalysts have been widely used in many important industrial heterogeneous processes such as hydrogenation and steam reforming owing to their sufficiently high activity yet significantly lower cost than that of alternative precious-metal-based catalysts.However, nickel catalysts are susceptible to deactivation.Understanding the adsorption and activation behavior of small molecules on the model catalyst surface is important to optimize the catalytic performance.Although many studies have been carried out in recent years, the initial oxidation process of nickel surface is still not fully understood, and the influence of the adsorption sequence of CO and O2 and their co-adsorption is controversial.In this study, the surface oxygen species on Ni( 111) and the coadsorption of CO and O2 were explored using high-resolution electron energy loss spectroscopy (HREELS), Auger electron spectroscopy (AES), and low energy electron diffraction (LEED).HREELS can provide useful information about the surface structure, surface-adsorbed species, adsorption sites, and interactions between surface oxygen species and CO on the surface.The results showed that there were two kinds of oxygen species after the oxidation of Ni(111), and the energy loss peaks at 54-58 meV were ascribed to surface chemisorbed oxygen species, and the peak at 69 meV to surface nickel oxide.The chemisorbed oxygen at low coverage displayed a LEED pattern of (2 × 2), revealing the formation of an ordered surface structure.As the amount of oxygen increased, the energy loss peak at 54 meV shifted to 58 meV.At an O2 partial pressure of 1 × 10 -8 Torr (1 Torr = 133.32Pa), the AES ratio of O/Ni remained almost unchanged after dosing 48 L, which indicated that the surface nickel oxide was relatively stable.The surface chemisorbed oxygen species was less stable, which could change to surface nickel oxide after annealing in vacuum.CO adsorbed on Ni(111) at room temperature with tri-hollow and a-top sites.Upon annealing in vacuum, a-top CO weakened first and then disappeared completely at 520 K, whereas tri-hollow CO was much more stable.The pre-adsorption of CO could suppress O2 adsorption and oxidation of the Ni(111) surface.The presence of oxygen could then gradually remove and replace CO with O2.The surface oxygen species preferred the tri-hollow sites, resulting in more a-top adsorbed CO during the co-adsorption of CO and oxygen.The surface chemisorbed oxygen species were more active and could react with CO at room temperature; however, the surface nickel oxide was less active, and could only be reduced at a higher temperature and higher partial pressure of CO.

A DFT Study of CO Catalytic Oxidation by N<sub>2</sub>O or O<sub>2</sub>on the Co<sub>3</sub>O<sub>4</sub>(110) Surface

A Dft Study Of Co Catalytic Oxidation By N2o Or O-2 On The Co3o4(110) Surface

Theoretical Studies of CO Oxidation with Lattice Oxygen on Co3O4 Surfaces

Structure Sensitivity of CO Oxidation on Co3O4: a DFT Study.

Reduction of NO with CO on the Co3O4(110)-B and CoO(110) Surfaces: A First-Principles Study

Density Functional Theory Study of CO Catalytic Oxidation on Co2B2/TiO2 (110) Surface

Adsorption and Oxidation of CO on Co3O4/Ir(100) Thin Films

Adsorption and Activation of O<sub>2</sub> and CO on the Ni(111) Surface

Insight into the Active Phase of CO Oxidation on Ni/Pt and NiO1−x/Pt Model Catalysts from a First Principles Investigation

Exploring reaction mechanism of CO oxidation over SrCoO3 catalyst: A DFT study

Direct CO oxidation by lattice oxygen on the SnO2(110) surface: a DFT study.

Origin of Extraordinarily High Catalytic Activity of Co3O4 and Its Morphological Chemistry for CO Oxidation at Low Temperature

Density Functional Theory Study of CO and O_2 Adsorption on NiFeB_2/TiO_2 Surface

Transition of surface phase of cobalt oxide during CO oxidation.

Competitive Deposition of C and O Species on Cobalt Surface in Fischer–Tropsch Synthesis Conditions: A Plausible Origin of Deactivation

Adsorption of CO on Rutile TiO2 (110)-1 × 1 Surface with Preadsorbed O Adatoms

Density functional theory study of CO and O2 adsorption on NiFeB2/TiO2 surface

A DFT+U Study of CO Oxidation at CeO2(110) and (111) Surfaces with Oxygen Vacancies

Density Functional Theory Study Of Co And O-2 Adsorption On Nifeb2/Tio2 Surface

Surface active sites on Co 3 O 4 nanobelt and nanocube model catalysts for CO oxidation

Surface active sites on Co3O4 nanobelt and nanocube model catalysts for CO oxidation