Abstract:The present report describes the preparation and characterization of large-bore particle-entrapped monolithic precolumns, which are suitable for incorporation into a two-dimensional liquid chromatography (2D-LC) system for proteome analysis. The fritless precolumns with different inner diameter (i.d.) (320 and 530μm) were rapidly and successfully prepared by entrapping octadecylsilica (ODS) particles (5μm, 300Ǻ) prepacked into fused silica capillaries with a sol–gel network, which was formed by hydrolysis and polycondensation of methyltriethoxysilane (MTES). By optimizing the composition of the sol solution, the resulting large-bore monolithic precolumns of 5mm length allow a flow rate of 20μL/min loading buffer at a reasonable low back pressure of 25bar or less and are capable of withstanding up to 300bar inlet pressure. Scanning electron micrograms of the precolumns profile showed that the evolving sol–gel network joined particles to each other and onto the column wall, and no cracking or shrinkage of the column bed was observed even in 530μm-i.d. capillary. The performance of the particle-entrapped monolithic precolumns used for preconcentration and desalting of proteolytic digest was evaluated by on-line coupling the large-bore precolumns with a capillary reversed-phase liquid chromatographic (RPLC) column followed by UV detection. The laboratory-made monolithic precolumns with 320 and 530μm i.d. were characterized by using BSA tryptic digest or peptide standards as the analytes with respect to sample loading capacity, linearity, recovery and reproducibility, etc. The results indicate that the large-bore and short precolumns (5mm×320μm i.d. or 5mm×530μm i.d.) allow sample fast loading at a flow rate of 30 or 60μL/min. The precolumns also have a mass loading capacity for BSA peptides of about 70μg and for standard peptides of about 80μg. Good linear calibration curves (R2>0.99) were obtained and the limits of detection (signal-to-noise ratio, S/N=3) were improved by more than 60-fold and were between 0.53 and 1.32ng/μL even with a UV absorbance detector. The total recovery was found to be approximately 90–100% for BSA digest and standard peptides. The day-to-day relative standard deviation (RSD) values for recoveries of BSA peptides on a single precolumn ranged from 4.66 to 7.56% and 2.68 to 3.05% for precolumn back pressure, while the column-to-column RSD values were 3.51–6.13% and 1.22–1.26% for recoveries of BSA peptides and precolumn back pressure, respectively. With good precolumn reproducibility, no significant degradation or decrease in precolumn performance was showed even after ∼150 preconcentration/desorption cycles. The precolumns also proved to be resistant to salt buffer with high concentration and low-pH mobile phase. The large-bore particle-entrapped monolithic precolumns will be further used in a high-throughput 2D-LC array system coupled with tandem matrix assisted laser desorption/ionization-time of flight–time of flight–mass spectrometry (MALDI-TOF–TOF–MS) detection for proteome analysis.

A Novel Sodium Bis(2-Ethylhexyl) Sulfosuccinate-Page System Suitable for the Separation of Small Peptides

An Improved SDS-PAGE Method for the Separation of Low Molecular Weight Polypeptides

A versatile electrophoresis system for the analysis of high- and low-molecular-weight proteins

Developing Protocols of Tricine-Sds-Page for Separation of Polypeptides in the Mass Range 1-30 Kda with Minigel Electrophoresis System

High‐speed Separation of Proteins by Sodium Dodecyl Sulfate‐capillary Gel Electrophoresis with Partial Translational Spontaneous Sample Injection

On-line Combination of Capillary Isoelectric Focusing and Capillary Non-Gel Sieving Electrophoresis Using a Hollow-Fiber Membrane Interface: a Novel Two-Dimensional Separation System for Proteins.

C18-Functionalized Amine-Bridged Hybrid Monoliths for Mass Spectrometry-Friendly Peptide Separation and Highly Sensitive Proteomic Analysis

SDS-PAGE focusing: preparative aspects

Exploration on Separation of Periplaneta Americana Small Peptides with Tricine-SDS-PAGE System

The Electrophoretic Separation of Low Molecular Weight Polypeptide

Separation of Peptides Using Off-Line Ph Gradient-Strong Cation Exchange Chromatography

Two‐dimensional Separation System by On‐line Hyphenation of Capillary Isoelectric Focusing with Pressurized Capillary Electrochromatography for Peptide and Protein Mapping

Capillary Sodium Dodecyl Sulfate Agarose Gel Electrophoresis of Proteins

Integration of Solid-Phase Extraction Membranes for Sample Multiplexing: Application to Rapid Protein Identification from Gel-Isolated Protein Extracts.

Electrophoretic Separation with 2-Mm Inner Diameter Fused-Silica Microcolumn Packed with Quartz Microncrystals and Its Application

Surface-Charged Hybrid Monolithic Column for MS-Compatible Peptide Separation with High Peak Capacity and Its Application in Proteomic Analysis

Capillary Trap Column with Strong Cation-Exchange Monolith for Automated Shotgun Proteome Analysis

Large-Bore Particle-Entrapped Monolithic Precolumns Prepared by A Sol-Gel Method for On-Line Peptides Trapping and Preconcentration in Multidimensional Liquid Chromatography System for Proteome Analysis

Microchip electrophoresis-SDS methods with high-resolution and silver stain sensitivity for quality screening and quantitation of protein products

Microfluidic 2-D PAGE Using Multifunctional in Situ Polyacrylamide Gels and Discontinuous Buffers

PEPPI-MS: Polyacrylamide-Gel-Based Prefractionation for Analysis of Intact Proteoforms and Protein Complexes by Mass Spectrometry