Abstract:An ambient aerosol concentration enrichment system coupled with ICP-MS for real-time monitoring of airborne radioactive particles is now under development. ICP-MS is very sensitive to sample introduction conditions, so it is necessary to develop an easy-use calibration method for on-line quantitative analysis in field application. In this paper, a calibration method using standard solution instead of monodisperse particles was established and validated preliminarily. First of all, four parameters for the method were determined experimentally, including: uptake flow rate and nebulisation efficiency of the Microconcentric nebuliser, nebulisation/transport efficiency of Aridus Desolvating Sample Introduction System, and Relative Sensitivity Factor between 159 Tb and 174 Yb. Then, monodisperse terbium nitrate particles were generated by a commercial Vibrating Orifice Aerosol Generator. Continuous aerosols of ytterbium nitrate droplets were nebulised from standard solution. They were mixed together, desolvated through the membrane dryer and introduced into ICP-MS for on-line analysis of terbium nitrate particles. The air sampled from nuclear environment was also introduced into ICP-MS to investigate the effect of flow rate on instrument responses. Finally, atom numbers of 159 Tb in discrete terbium nitrate particles were determined using the calibration method and compared to the calculated value. Results show that when air flow rate increase from 10 mL min−1 to 100 mL min−1, the ratio of 159 Tb ion count to 174 Yb ion intensity keeps constant although instrument sensitivity decreases by a factor of 25. The relative standard deviation of 159 Tb atom number measured is better than 18%. The discrepancy with the calculated value could be attributed to the over-estimation of atom number in the particles generated by VOAG because there was some liquid leakage in the VOAG.

Study of On-line Chemical Analysis of Aerosol Individual Particles with ICP-MS

Preliminary Study on Aerosol Particle Addition Calibration Method for On-Line Quantitative Analysis of Airborne Radioactive Particles with Icp-Ms

Development of Aerosol Sample Introduction Interface Coupled with ICP-MS for Direct Introduction and Quantitative Online Monitoring of Environmental Aerosol

Scanning Supersaturation Condensation Particle Counter Applied As a Nano-Ccn Counter for Size-Resolved Analysis of the Hygroscopicity and Chemical Composition of Nanoparticles

Review of Online Measurement Techniques for Chemical Composition of Atmospheric Clusters and Sub-20 Nm Particles

Real time bipolar time-of-flight mass spectrometer for analyzing single aerosol particles

Dilution versus fractionation: Separation technologies hyphenated with spICP-MS for characterizing metallic nanoparticles in aerosols

Chemical composition of different size ultrafine particulate matter measured by nanoparticle chemical ionization mass spectrometer

Real-time detection of molecular structures and metal components within airborne particles using concurrent Raman and Spark emission spectroscopy

Size and isotope analysis of individual nanoparticles by multi-collector ICP-MS using "event-triggered signal capture" with a high-speed oscilloscope

Development of an Automatic Measurement System Using Atmospheric Pressure Photoionization Ultrahigh-Resolution Mass Spectrometry and Application for On-Line Analysis of Particulate Matter

On-line Characterization of Individual Particles from Automobile Emission by ATOFMS

On-line Analysis of Mass Spectra of Individual Aerosol Particles Using Fuzzy Clustering Algorithms

New Approach for Near-Real-Time Measurement of Elemental Composition of Aerosol Using Laser-Induced Breakdown Spectroscopy

Quantitative chemical assay of nanogram-level particulate matter using aerosol mass spectrometry: characterization of particles collected from uncrewed atmospheric measurement platforms

Application of On-line Single Particle Aerosol Mass Spectrometry(SPAMS) for Studying Major Components in Fine Particulate Matter

Simultaneous determination of aerosol inorganic and organic nitrogen by thermal evolution and chemiluminescence detection

Rotating disk diluter hyphenated with single particle ICP-MS as an online dilution and sampling platform for metallic nanoparticles characterization in ambient aerosol

Online high temporal resolution measurement of atmospheric sulfate and sulfur trioxide with a light emitting diode and liquid core waveguide-based sensor.

Investigating Aerosol Chemistry Using Real-Time Single Particle Mass Spectrometry: A Viewpoint on Its Recent Development

Data Analysis for the Characterization of Nanoparticles with Single Particle Inductively Coupled Plasma Mass Spectrometry: from Microsecond to Millisecond Dwell Times.