Abstract:The simulation model of an unloading welding transformer was established on the basis of MATLAB software, and the modeling principle was described in detail in the paper. The model was made up of three submodels, i.e. the linear inductor sub-model, the non-linear inductor sub-model and series connection sub-model controlled by current, and these sub-models were jointed together by means of segmented linearization. The simulating results showed that, in the conditions of the high convert frequency and the large cross section of the magnet core of a welding transformer, the non-linear inductor sub-model can be substituted by a linear inductor sub-model in the model; and the leakage reactance in the welding transformer is one of the main reasons of producing over-current and aver-voltage in the inverter. The simulation results demonstrate that the over-voltage produced by leakage reactance is nearly two times of the input voltage supplied to the transformer, and the lasting time of over-voltage depends on t ime constant τ1. With reducing of τ1, the amplitude of the over-current will increase, and the lasting time becomes shorter. Contrarily, with increasing of τ1, the amplitude of the over-current will decrease, and the lasting time becomes longer. The model has played the important role for the development of the inverter resistance welding machine.

Study on Modeling and Simulation of Short Circuit Transfer of Inverter Arc Welding System

Modeling and Simulation of Arc Welding Power

Study on Dynamic Characteristics of Inverter Arc Welding Power Supply Based on Double-Loop Control

Three-level Inverter and Induction Machine's SVV Control Technology and Its Simulation

Modeling and simulating of unloading welding transformer

Simulation research on the VP PMIG welding power source-arc system

Design of Arc Welding Power and Matlab Simulation

Modeling and Simulation of Transformer Inter-Turn Short-Circuit Faults Based on Field-Circuit Coupling

Research on the Simulation of Vacuum Arc under Low Current Interruption

Study on control system for MMA welding power source

A Coupled 3D FEM-Distribute Circuit Model for Numerical Analysis of Small Time Scale Transients of an IGBT based Inverter

Simulation and Experiment of Influence of Metal Steam on Arc Process in Low Voltage Circuit Breaker

Simulation of Fault Arc Using Conventional Arc Models

Analysis and control of short-circuit experience in short-circuit CO2 welding

Simulation Experiments and Research of Arc for Low Voltage Circuit Breaker

Improvements in Designing the Main Circuit of Arc Welding Inverter and the Experimental Verification

The Research of Electric Arc Simulation in Low Voltage Switching Devices

Research on Short Circuit Operation Control Strategy of a Superconducting Magnet Power Supply for CRAFT

Research of Simulation Technique of Electric Arc in Air Switch and Its Applications

Study on three-dimensional output characteristic control for welding arc

Modeling and Simulation of Weaving Arc in Submerged Arc Welding