Abstract:To measure the carbon content of the fly ash of a CFB boiler one still continues to adopt the loss-on-ignition method traditionally used for measuring carbon content of the fly ash of pulverized coal-fired boilers. As the mineral constituent of the fly ash of a CFB boiler is different from that of a pulverized coal-fired one, the use of the loss-on-ignition method for measuring carbon content of the fly ash of a CFB boiler may produce a certain system error. The authors have adopted the loss-on-ignition method combined with a TGA-FTIR (thermogravimetric analyzer-Fourier infrared spectrum) method to measure the carbon content of the fly ash of the CFB boiler and analyzed the system error involved in the measurement by using the loss-on-ignition method. The results of the measurements show that in case of using China National Electric Power Industry Standard DL/L567.6-95 Method B for measuring combustible matter in fly ash and slag of a CFB boiler the system error should involve the decomposition of sulfate and release of water of crystallization and hydration from mineral constituents. When using this method to check the performance and efficiency of a CFB boiler unit, one shall take into account the effect of these factors. On the basis of TGA-FTIR experiments, presented is a new TGA method for measuring the carbon content of fly ash of a CFB boiler, which can avoid the system error caused by the decomposition of sulfate and the release of water of crystallization and hydration from mineral constituents. In the meantime, the system error resulting from high-temperature cracking of newly produced carbon-containing organic matter can be negligible. The result thus measured further approximates to the actual carbon content of the fly ash of the CFB boiler.

System Error Present When Measuring the Carbon Content of the Fly-ash of a Circulating Fluidized Bed Boiler by Using a Loss-on-ignition Method

Research on Carbon Content in Fly Ash from Circulating Fluidized Bed Boilers

STUDY ON CORRELATIVITY BETWEEN UNBURNED CARBON IN FLY ASH OF BOILERS AND THE COMBUSTION PROPERTIES OF COAL

Unburned Carbon Loss in Fly Ash of CFB Boilers Burning Hard Coal

Coal Combustion Efficiency in Circulation Fluidized Bed

Characterization of fly ash and unburned carbon from CFB boiler with burning Fujian anthracite

Coal combustion efficiency in CFB boiler

EXPERIMENTAL TECHNIQUE ON COAL ASH FORMATION IN CFB COMBUSTION

Carbon Formation Mechanism in Fly Ash of Circulating Fluidized Bed Boilers

Research on On-Site Measurement Factors and Performance of Coal Calorific Value Based on Laser Ignition

Fly Ash Reburn To Enhance The Combustion Efficiency Of Cfb Boiler Burning Fujian Anthracite

The Investigation of Carbon Content in Fly Ash for a BP Neural Network-based Pulverized Coal-fired Boiler

Research on the Measurement Method of Fuel Feeding Temperature During Circulating Fluidized Bed Boiler's Start‐up

Measure carbon content in fly ash by infrared reflection method

Non-linear Characteristics on Carbon Content of Fly Ash for Different Size Particles in Pulverized Coal Boiler

Cause Analysis on High Carbon Content in Fly Ash of Boilers

The Investigation of the Coal Ignition Temperature and Ignition Characteristics in an Oxygen-Enriched FBR

Comparison of Heating Losses and Macro Thermogravimetric Analysis Procedures for Estimating Unburned Carbon in Combustion Residues

A New Route for Unburned Carbon Concentration Measurements Eliminating Mineral Content and Coal Rank Effects

The Fundamental Studies on Combustion of Sintering Flue Gas in Circulating Fluidized Bed

A method for measuring the solid circulation rates of CFB boilers based on the particle flow-around principle