Abstract:For structural health monitoring of large bridges,the traditional manual detection is inadequate because of its strong subjectivity,bad entirety and bad timeliness.The widely used wired health monitoring system also has some problems in the actual applications.For example,it is hard to wire in some area and it is easy to be affected by environment.Using wireless sensor networks in bridge structural health monitoring not only retains the advantage of wired health monitoring system but also makes up for its deficiencies in the applications.The paper describes the composition of the whole system,and discusses the composition of wireless sensor nodes in the monitoring area of the system.Through studying the composition of base station,the paper gives the role of base station in the health monitoring system.On the basis of the composition of wireless sensor nodes,the paper addresses the mean value drift of the accelerometer output resulting from temperature changes.It gives a method to calibrate the output value of using temperature compensation technology.In order to verify this method,we give a comparison between uncorrected accelerometer readings and corrected accelerometer readings.Then,through proposing the necessity of time synchronization of all nodes before data collection,the paper discusses the principle of time synchronization.At last,we built a health monitoring system which was composed by data collection,data transmission,data reception and data analysis.And we tested the system in the anchor cable of Runyang Yangtze River Bridge.We installed the wireless sensor node in the anchor cable and obtained its vibration information through accelerometer.Then these data was sent to the base station,and to monitoring center in final.By analyzing these data,the vibration frequency spectrum of anchor cables could be obtained.Through analyzing the frequency,the strength of bridge's cables would be figured out.It is useful to identify if the bridge is in a healthy status.If the data deviates from the normal range,the monitoring center will respond in time.At last,the paper gives a conclusion that the wireless system is suitable for bridge structural health monitoring field and useful for actual application.

Bridge structural health monitoring system based on a tree structured wireless sensor network

Bridge structural health monitoring system based on wireless sensor networks

Implementation of SHM System for Hangzhou East Railway Station Using a Wireless Sensor Network

Bridge Health Monitoring System Based on Integration of Heterogeneous Structural Network for Wireless and Wired

Towards A Novel In-Community Healthcare Monitoring System over Wireless Sensor Networks

A Spanning Routing Tree protocol based on State Diffusion for mobile sensor networks.

A new method for bridge structural health monitoring based on wireless sensor networks

Wireless Sensor Networks for Community Healthcare Monitoring

Large-Scale Bridge Structural Health Monitoring System Based on Smart Sensor Networks

Wireless Sensor Networks for Bridge Structural Health Monitoring

Energy-Efficient Heterogeneous Wireless Sensor Deployment with Multiple Objectives for Structural Health Monitoring

Recent Developments on Wireless Sensor Networks Technology for Bridge Health Monitoring

Strain Sensor-Based Wireless Measurement System for Bridge

A Structural Health Monitoring System Using Wireless Sensor Network

A bridge cluster health monitoring system based on 3G wireless sensor network

Design and implementation of wireless bridge health monitoring system

Applying ZigBee wireless sensor and control network for bridge safety monitoring

Energy‐aware versatile wireless sensor network configuration for structural health monitoring

Autonomous structural health monitoring using wireless smart sensors on a cable-stayed bridge

Wireless Sensor Integration for Bridge Model Health Monitoring

The design of densely measured points long-term monitoring system based on wireless sensor network