Abstract:It is necessary to elucidate the crystallization thermodynamic of mineralogical phases during the cooling process of the molten BFS with different chemical composition, because the high-melting point mineral phase maybe crystallized during the fiber forming and thereafter cooling process. Thermodynamic calculation software FactSage6.4 and the hot remelting experiments were performed to explore the influence of basicity, Al2O3 content and MgO content on the crystallization of mineralogical components and their transformation. The results showed that the main mineralography of the CaO-SiO2-Al2O3-MgO quaternary slag system was melilite, and a certain amount of anorthite and calcium metasilicate. The crystallographic temperature of melilite is increased with the increasing of basicity, MgO and Al2O3 content, which has a significant impact on the utilization performance of the mineral wool prepared with the hot blast furnace slag directly. With the increasing of basicity, there was a tendency that crystallographic amount of melilite increased to the summit and then declined, while the amount of anorthite and calcium metasilicate decreased consistently. Finally, these two mineralogical components could be replaced by magnesium rhodonite and spinel with the increasing of basicity. When the basicity and MgO content were 1.0 and 9 %, the crystallographic mass ratio of melilite and anorthite increased, while that of calcium silicate declined, and replaced by spinel finally with the increasing of Al2O3 content. When the basicity and Al2O3 content were 1.0 and 13 %, the crystallographic mass ratio of melilite increased, while that of anorthite and calcium silicate declined, and replaced by pyroxene and spinel with the increasing of MgO content. To decline fiberization temperature of the melt BFS, the basicity, MgO and Al2O3 content should be decreased during the modification process of chemical composition, because the crystallization temperature of the primary crystalline phase in the slag system without modification.

Influence of Quartz Particle Size on Hydrothermal Solidification of Blast Furnace Slag

Influence of Tobermorite Formation on Mechanical Properties of Hydrothermally Solidified Blast Furnace Slag

Hydrothermal Solidification of Blast Furnace Slag by Formation of Tobermorite

Influence of Additions of Coal Fly Ash and Quartz on Hydrothermal Solidification of Blast Furnace Slag

Long-term Thermal Performance of Oil Well Cement Modified by Silica Flour with Different Particle Sizes in HTHP Environment

Hydrothermal solidification of municipal solid waste incineration bottom ash with slag addition.

Effect of Particle Size of Quartz Sand Filler on Microstructure and Strength of Alkali-Activated Slag-Based Materials

Investigation on the Effect of MgO Content on the Crystallization Behavior of Synthetic BF Slag

Potential utilization of riverbed sediments by hydrothermal solidification and its hardening mechanism.

Crystallization Behavior of Blast Furnace Slag Modified by Adding Iron Ore Tailing

Effect of W(mgo)/w(al2o3) Ratio and Basicity on Microstructure and Metallurgical Properties of Blast Furnace Slag

Thermodynamic study on crystallization behavior of fibrosis process of quenching and tempering blast furnace slag

Effect of Composition and Temperature on Structure and Early Hydration Activity of Modified Steel Slag

Crystallisation Behaviour of Blast Furnace Slag Modified by Adding Fly Ash

Study on Crystallization Behavior in Fibrosis Process of Molten Blast Furnace Slag

Influence of B2O3 on the Thermophysical Properties of Molten Blast Furnace Slag

Thermodynamic Simulation on Mineralogical Composition of CaO–SiO2–Al2O3–MgO Quaternary Slag System

Influence of Crystallization Behavior of Gas Quenching Blast Furnace Slag on the Preparation of Amorphous Slag Beads

The Solidification of Lead-Zinc Smelting Slag through Bentonite Supported Alkali-Activated Slag Cementitious Material

Effect of Pre-calcination of Lead-zinc Tailings on the Activation of Blast Furnace Slag

Solidification Behaviour and Viscosity Behaviour of Blast Furnace Slag Modified by Tailings