Abstract:In recent years, slope units have been widely utilized in landslide susceptibility mapping and geologi-cal hazard assessment. Slope units automatically derived from high-quality DTMs, partition the territory into hydrological regions between drainage and divide lines. The division method of slope units conducts subwater-shed segmentation on elevation and the reversal to extract ridge lines and valley lines, then overlays these ter-rain feature lines. However, these resultant units are unable to match with geomorphology background where intermountain basins or large open valleys exist. In this article, according to the basic morphometic system of elevation and the derived variables, slope is derivative of elevation while curvature is that of slope, thus the break of slope should be indicated by curvature instead of elevation. The disability of indicating variation of slope is regarded as the main reason for the limitation in the conventional method. According to the theory of watershed segmentation of mean curvature, the division method of slope units is improved by overlaying wa-tershed boundaries on curvature and the reversal in ArcGIS. Firstly, the DEM should be smoothed twice with a 5×5 average filter in order to reduce the effect of noise and small scale variation in the DEM. The curvature is then calculated from the filtered DEM using the Arctool named Curvature. After that, watershed boundaries are generated mainly through computing flow direction, scouting sink and dividing watershed in the curvature image, and this image should be reversed for watershed boundaries on the reversal curvature. Finally, slope units can be separated from each other by these two kinds of boundaries which are further combined into the boundaries of slope units. Giving an example from Huachi County of Gansu Province, elevation layer in the resolution of 20 m was used as input data, and both two methods were then applied for slope unit division. Compared with the conventional method, the revised approach not only uses ridge lines and valley lines to seg-ment slope units, but also utilizes tableland boundaries and open valley boundaries to separate horizontal sur-face from the inclined. The revised approach may give a new definition that slope units should be divided by ridge lines, valley lines, tableland boundaries and open valley boundaries. Also the revised method utilizes wa-tershed segmentation on curvature instead of subwatershed division on DEM where filling sinks perhaps causes the serious change of reversal elevation. Furthermore, the resultant units have relatively uniform size and shape, more than 80%of them with the area from 0.1×104 to 6×104m2 and about 60%between circle and tri-angle shape, which are more suitable for landslide hazard evaluation. It is worth mentioning that the revised method would be more competitive than the original in some regions with large area of horizontal surface, just like Loess Tableland and reservoir surface.

Regional Slope Length and Slope Steepness Factor Extraction Algorithm Based on GIS

Method of Extracting LS Factor at Watershed Scale Based on DEM

An Improved Method for Calculating Slope Length (λ) and the LS Parameters of the Revised Universal Soil Loss Equation for Large Watersheds

A Parallel Algorithm for Erosion Slope Length Calculation Based on Grid Terrain Datasets

Study of slope length (L) extraction based on slope streamline and the comparison of method results

Ecological Prediction Model Of Soil Erosion In Small Watershed Based On Gis

Research on Basic Ecological Landform Unit and Model of Soil Erosion Estimation and Predict in Small Watershed

Ecological Prediction Model and Experimental Simulation of Soil Water Erosion in Small Watershed:Taking Liudaogou Small Watershed As an Example

Simulation of the Erosion and Drainage Development of Loess Surface Based on Gis

Extraction of water information in complex water-net plain with Chinese GF-2 remotely sensed images

Modification of the RUSLE slope length factor based on a multiple flow algorithm considering vertical leakage at karst landscapes

An Optimised Region-Growing Algorithm for Extraction of the Loess Shoulder-Line from DEMs

A new high-resolution global topographic factor dataset calculated based on SRTM

Hillslope Soil Erosion Simulation System Based on Plug-in Technique and GIS

A New Approach of Fast Calculating the Sloped Terrace Earthwork in the Hilly Regions

An Approach to Improving Slope Unit Division Using GIS Technique

Estimating the CSLE Biological Conservation Measures' B-Factor Using Google Earth's Engine

Research of the Visualization System for Soil Slope Stability Analysis Based on GIS

Three-dimensional slope modelling method and its stability based on coupled GIS and numerical simulation software

Quantitative analysis of error in extracting slope length from grid-based digital elevation model

Design and Implement of the High-Cutting Slope's Integrated Model Based on 3D GIS