Abstract:The present study assesses RANS-based turbulence models to simulate the isothermal confined swirling flow in a combustor representing a constituent can combustor of the can-annular configuration used in jet engines. The two-equation models (standard k−ε , realizable k−ε , standard k−ω , SST k−ω ), and seven-equation model (linear pressure strain - Reynolds stress model, LPS-RSM), are assessed by comparing their predictions of mean axial velocity, mean transverse velocity, turbulent kinetic energy, and shear stress with the experimental data at two different positions (i.e., the primary and dilution hole planes) in the combustor. While the two-equation models generally have failed to predict the confined swirling flow at both positions accurately, the SST k−ω model yielded the most accurate, followed by standard k−ω and realizable k−ε models. The discrepancies between the computational and experimental results could be attributed to the isotropic turbulence assumptions, which, however, are invalid for confined swirling flows. Further, the two-equation model formulations cannot capture the intricacies of vortex flow and its interaction with the surroundings in confined swirling flows. The LPS-RSM, which considers turbulence anisotropy, showed some promise, although overpredicted results follow the trend with experimental values at the primary holes plane. However, at the dilution holes plane, the model overpredicted the velocity field, and underestimated the turbulence field, including turbulent kinetic energy and shear stress. These observed discrepancies can be ascribed to the pressure-strain correlation in the LPS-RSM, which assumes the pressure is a linear function of the strain-rate tensor. However, this linear assumption is quite simplistic for complex flows. Further, the influence of discretization (SOU and third-order MUSCL) schemes of convective terms is also assessed, and the differences in predictions resulted from MUSCL scheme having lower diffusion and superior ability to capture sharper gradients, however, did not translate into improving the solution accuracy. Hence, this study suggests that more advanced high-fidelity turbulence models (e.g., hybrid RANS-LES, LES, DNS) are needed to accurately predict the confined swirling flow in combustors.

Comparison Between Realizable κ-ε and RSM Model in the Simulation for a Swirl Burner

Numerical Simulation of Swirling Burners Outlet Gas Field with Different Turbulence Model

Computational investigation of oxy-combustion of pulverized coal and biomass in a swirl burner

The impact of turbulence and combustion models on flames and emissions in a low swirl burner

Assessment of turbulence-chemistry interaction models in MILD combustion regime

Numerical analysis of the effect of swirl angle and fuel equivalence ratio on the methanol combustion characteristics in a swirl burner

Influence of the turbulence model on the numerical predictions of cold turbulent flow in a heavy-duty gas turbine DLN combustor

Numerical Simulation of Gas-Particle Flows with Different Swirl Numbers in a Swirl Burner

Simulation of Turbulent Combustion in DLR Scramjet

Numerical Simulation and Flame Characteristics Analysis of Non-Premixed Swirling Combustion

Direct Numerical Simulations and Analysis of Three-Dimensional N-Heptane Spray Flames in a Model Swirl Combustor

Numerical Study of Turbulent Swirling Diffusion Flame Under Lean and Rich Conditions Using Turbulence Realizable k-epsilon Model

Numerical Simulating for the Swirling Jet Two-Phase Flow from Pulverized Coal Rich/Lean Burner

Numerical Simulation of Swirling Burner in Cold State

Assessment of RANS-based turbulence models for isothermal confined swirling flow in a realistic can-type gas turbine combustor application

Validation and analyses of RANS CFD models for turbulent heat transfer of hydrocarbon fuels at supercritical pressures

LES of Biomass Syngas Combustion in a Swirl Stabilised Burner: Model Validation and Predictions

Studies on a Swirling Heptane Spray Flame by Large-Eddy Simulation

SIMULATION OF GAS-PARTICLE TURBULENT FLOW IN SWIRL COMBUSTOR

Simulation of Turbulent Reacting Flow in a Swirl Combustor

Experimental and numerical study on flow field characteristics of a combustion chamber with double-stage counter-rotating swirlers