Abstract:Due to the disadvantages of poor friction and low wear resistance, the application of Al-Si alloys with unique properties in pistons is limited. In this work, TiAlN ceramic coatings were prepared by filtered cathode vacuum arc technique to improve the surface properties of Al-Si alloys. To overcome the high residual stress of hard coatings growth on soft substrate surfaces due to interfacial mismatch and defect accumulation, gradient and multilayer film structures were adopted to improve adhesion strength. The effects of film structure on the microstructure, mechanical and tribological properties of coatings were systematically investigated. The results showed that the coatings with different film structures showed a multiphase microstructure with the dominated phase of TiAlN and a small amount of AlTi and TiN phases. Monolayer and multilayer coatings exhibited TiAlN (111) orientation, while the gradient coating showed (220) orientation due to the growth of columnar to equiaxed crystals. Compared with the monolayer coating, TiAlN coatings with gradient and multilayer structures had significantly reduced compressive stress and improved adhesion and scratch propagation resistance. Among them, the multilayer coating showed the lowest friction coefficient (~0.44) and wear rate (~5.14 × 10−5 mm3/Nm), which were attributed to the high hardness (~31.01 GPa), toughness (H/E = 0.135, H3/E2 = 0.563 GPa), critical load LC3 (~26.58 N). Interfacial effects in the multilayer structure could enhance synergy of the coating, thereby preventing crack initiation and propagation and adhesion failure.

Formation of an α-SiAlON Layer on ß-SiAlON and Its Effect on Mechanical Properties

Microstructure Characteristics And High-Temperature Performance Of In-Situ Reinforced Alpha-Sialon Ceramics

Synthesis of single phase β-SiAlON ceramics by reaction-bonded sintering using Si and Al2O3 as raw materials

Effect of Z Values on the Microstructure and Mechanical Properties of Post-sintered Reaction Bonded β-SiAlON

Process and mechanical properties of beta ' Sialon reaction bonded SiC

Sintering And Mechanical Properties Of Aln-Rich Ceramics In The Sic-Aln System

Microstructure and Mechanical Properties of SiAlON Ceramics with Porous Structure

Synthesis and properties of porous single-phase beta '-SiAlON ceramics

Tuning the Surface Characteristic of Al-Si Alloys and Its Impacts on the Formation of Micro Arc Oxidation Layers

Investigation on Mechanical Properties of AlON Ceramics Synthesized by Spark Plasma Sintering

Fabrication and Evaluation of β-SiAlON Nanoceramics

SiC and ZrN Nano-Particulate Reinforced AlON Composites: Preparation, Mechanical Properties and Toughening Mechanisms

Effect Of Z Values On The Microstructure And Mechanical Properties Of Post-Sintered Reaction Bonded Beta-Sialon

Preparation, Oxidation Property and Mechanism of Si3N4/O′-SiAlON Composite Ceramics

Crystallization of AlON Layers and Its Effects on the Microstructure and Hardness of Reactively Synthesized ZrN/AlON Nanomultilayers

Laser Surface Modification of Al-Si Alloy--Laser Surface Alloying (LSA)

Influence of film structure on the microstructure and properties of TiAlN coatings on Al-Si alloys

Oxidation Behavior of Β-Sialon Powders Fabricated by Combustion Synthesis

Solid-state NMR and XRD study of α-SiAlON powders prepared by combustion synthesis

Study of Mechanical Property, Oxidation Property and Mechanism of Si3N4/O′-SiAlON Composites Fabricated by Adding Different Sizes of SiO2

Synthesis and Properties of Porous Single-Phase β′-SiAlON Ceramics