Electrospun Regenerated Silk Fibroin Nanofibers: the Fiber Diameter Distributions and Mechanical Properties

PAN Zhi-juan,QIU Xin-wei,LI Chun-ping,WANG Jian-min,MIAO Heng-yun
DOI: https://doi.org/10.3969/j.issn.1673-2812.2006.02.005
2006-01-01
Abstract:Electrospinning was used to fabricate regenerated silk fibroin nanofiber (ERSF) mats with fiber diameter range 50~1000nm. Degummed Bombyx mori silk was dissolved in a ternary solvent system of CaCl2/CH3CH2OH/H2O in 1∶2∶8 mole ratio at 60℃,and lyophilized SF was dissolved in 98% formic acid to obtain regenerated SF solution for electrospinning. The diameter distributions of ERSF spun at various spinning conditions were investigated. 7wt% was a critical concentration of SF solution for better spinnability at a special vol-tage and distance from the tip of capillary to the collector screen (C-SD). The fiber diameter increased with a concentration but decreased with a C-SD, and more uniform SF nanofibers were obtained at a larger C-SD. The effect of voltage on the ERSF was also investigated. When voltage was above a certain value, electrospun regenerated SF nanofibers became thin and even. 50-150nm electrospun SF accounted for about 80% at the spinning conditions of 9wt% concentration, 12cm C-D and 15KV voltage. The mat was treated by methanol or acetone to decrease its contraction in water. Mechanical properties are important for the practical use of the ERSF mats, thus we measured the stress-strain behaviors of the as-spun and chemical treated mats.
What problem does this paper attempt to address?