Abstract:The plastic deformation behavior of metal plates has been proved to be affected by loading paths. Plastic flow is a critical component in the mechanical description of plastic deformation, like yield and hardening. In this work, the anisotropic plastic flow of two metal plates (16MnCr5 and S420MC) under non-proportional loading conditions was investigated. Large specimens manufactured along different orientations were pre-tensioned up to various strain levels; subsequently, small uniaxial tensile specimens were cut from the pre-tensioned specimens along different orientations with the interval of 15°, and then loaded to rupture. Meanwhile, the r-value, a measure of anisotropic plastic flow, was recorded. Result shows that for the studied plates which had constant r-value in the monotonic uniaxial tensile tests, a downward evolution of the r-value against plastic strain was observed when the Schmitt angle of two stage loading directions was greater than 90°. As the plastic strain in the subsequent loading stage accumulated, the r-value dropped from a higher level to its original level within a strain range about 6.0%. Based on the transient r-value evolution, a HEXAH-based evolutionary plastic potential model was constructed within the framework of non-associated flow (non-AF) theory. In the model, a local ellipse-shape distortion of the plastic potential surface was defined during plastic deformation process and when the Schmitt angel exceeded 90°, such distortion caused a downward evolution of the r-value in the subsequent deformation. The calibration result indicates that the model could reproduce the transient r-value response relevant to loading path change. The proposed evolutionary plastic potential model can be applied together with different anisotropic hardening models in the non-AF theory to give a detailed description of the plastic deformation behavior and hopefully provide a solution for the accurate simulation of the complex sheet metal forming process.

Visualization of Stress and Strain Fields in Complex Plastic Bulk Forming

Deforming Division and Visualization in Plastic Bulk Forming Process

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Calculation and Discussion of Welding Stress and Strain Field

Research on material flow stress models in common use

Dynamic Visualization of Stress/Strain Distribution and Fatigue Crack Propagation by an Organic Mechanoresponsive AIE Luminogen

Experimental and Modeling Investigation on Anisotropic Plastic Flow of Metal Plates under Nonproportional Loading Conditions

Non-associated anisotropic plasticity of metal sheets based on the distortional concept

MULTI-STEP NUMERICAL SIMULATION OF BULK METAL FORMING PROCESSES BASED ON DEFOR MATIoN THEORY OF PLASTICITY

Micro/meso scale metallic sheet forming process analysis based on the strain gradient plasticity theory

Calculation and Discussion of Welding Plastic Strain

Rapid Finite Element Analysis of Bulk Metal Forming Process Based on Deformation Theory

Large strain flow curve identification for sheet metals under complex stress states

Analysis of Stress-strain in the Plastic State

Applying Photo-Plastics in Analyzing the Mechanism of Strengthen Anti-Fatigue in the Case of Cold-Worked Hole

Evaluation of Plastic Deformation During Metal Forming by Using Lode Parameter

A Comprehensive Experiment-Based Approach to Generate Stress Field and Slip Lines in Cutting Process

Finite Element Analysis of Highly Strained Zones of Formed Aluminum Sheet by Hybrid Forming of Sheet Metal and Plastic

Numerical analysis of strain distribution in bulging process of sheet elastic flexible-die forming

Visualization method for stress-field evolution during rapid crack propagation using 3D printing and photoelastic testing techniques

Forming Defects Analysis of Auto-Panel Stamped Part with Experimental Strain Approach