Standardized Extract Preparation and Quality Control of Radix Rehmanniae

鲁艳柳,王长虹,王峥涛
DOI: https://doi.org/10.3969/j.issn.1008-861x.2008.06.021
2008-01-01
Abstract:Objective:To optimize preparation of standard extract from Radix Rehmanniae and establish quality control for the standard extract.Methods:XDA-1 macroporous resin was used to prepare standard extract from Radix Rehmanniae and the method of determining the content of catalpol in the standard extract with HPLC was established.Results:The optimal parameters for adsorption were:concentration of feed solution 2.23 mg/ml;flow rate 0.6 BV/h.The adsorption capacity was determined as 9.79 mg/g on XDA-1 resin.The gradient elution program was water for 2.5 BV, flow rate 2.4 BV/h;then 20% ethanol for 7.5 BV, flow rate 1.2 BV/h.After one run treatment with XDA-1 resin, the concentration of catalpol in the product increased from 1.82% to 10.26%, 5.6 folds of that in untreated extract.The content of catalpol presents a good linearity with the area of peak in the range of 7.86~0.12 mg/m(lr=0.999 5), the average recovery rate was 101.06 % and RSD was 2.29 %.Conclusion:The method of preparing standard extract from Radix Rehmanniae with macroporous resin is effective and practicable and determination of catalpol content with HPLC can be used as quality control for the standard extract.The study could provide prerequisite for further study of standard extract from Radix Rehmanniae.
What problem does this paper attempt to address?