Abstract:Various photocatalysts have been fabricated and tested for the treatment of water and wastewater. As visible light-driven photocatalysts, bismuth oxybromide nanomaterials have weak responses to visible light and low activities of using photogenerated h(+) to produce hydroxyl radicals (center dot OH), both of which are limited by their band structures. Thus, modification of bismuth oxybromide to form an optimized band structure is essential to enhance its photocatalytic activity for environmental applications. In this work, an oxygen-rich bismuth oxybromide nanomaterial, Bi24O31Br10 nanobelt, was fabricated using a solvothermal method, which possessed a narrower band gap and a more positive position of valance band top. As a result, this catalyst exhibited a strong response to visible light and produced large quantities of center dot OH directly via its photogenerated h(+), which contributed to the outstanding performance of photocatalysis, as evidenced by the experimental results and density functional theoretical (DFT) calculations. Under visible light irradiation, the Bi24O31Br10 nanobelt exhibited a substantially enhanced photocatalytic efficiency for the degradation of bisphenol A compared to those of Bi24O31Br10 and BiOBr nanosheets. Moreover, this catalyst could resist most interfering ions and was able to treat two types of actual industrial wastewaters efficiently. This work elucidates a new approach to modify photo catalysts and is helpful to expand practical applications of photocatalytic technologies for water and wastewater treatment.

The Photocatalytic Properties of Bismuth Oxide Films Prepared Through the Sol–gel Method

Thin Bismuth Oxide Films Prepared Through the Sol–gel Method As Photocatalyst

Room-temperature Fabrication of Bismuth Oxybromide/oxyiodide Photocatalyst and Efficient Degradation of Phenolic Pollutants under Visible Light.

Properties of Bi2O3 Thin Films Prepared Via a Modified Pechini Route

Influence of Heat Treatment on Photocatalytic Performance of BiVO4synthesised by Sol–gel Method

Preparation, Performance and Mechanism Study of High-Efficient BiOI/BiOBr Visible Light Photocatalyst

Understanding the composition and electronic structure dependent photocatalytic performance of bismuth oxyiodides

Photocatalytic Properties of Bismuth Oxyiodide Nanomaterials with Different Morphologies

Photocatalytic Property of Cu2+-doped Bi2O3 Films under Visible Light Prepared by the Sol–gel Method

Effects of Synthesis Temperatures on the Photocatalytic Activities of Bismuth Oxides for Phenol and Water Oxidation under Visible Light

Controlled Synthesis of Bismuth Oxyiodide Toward Optimization of Photocatalytic Performance

The effect of solvents and surfactants on morphology and visible-light photocatalytic activity of BiFeO 3 microcrystals

Solvothermal Synthesis of Layered BiOCl Nanosheets and Their Efficient VisibleLight-Induced Photocatalytic Activities

Influence of Different Solvents on the Performance of Bismuth-Based Photocatalyst for Mercury Removal

Controllable synthesis, characterization and photocatalytic performance of four kinds of bismuth-based materials

Photocatalytic Study of Zinc Oxide with Different Bismuth Doping

Solvothermal Fabrication Of Bi2fe4o9 And Its Photocatalytic Properties

Preparation, characterization and photocatalytic degradation efficacy of bismuth oxide under visible and ultraviolet light

Phase Transformation and Photocatalytic Properties of Bi2o3 Prepared Using A Precipitation Method

Enhanced activity of bismuth-compounded TiO2 nanoparticles for photocatalytically degrading rhodamine B solution

Direct Generation of Hydroxyl Radicals over Bismuth Oxybromide Nanobelts with Tuned Band Structure for Photocatalytic Pollutant Degradation under Visible Light Irradiation