Abstract:This work proposes a new speed-amplified multi-stable tri-hybrid energy harvesting technique via the multi-stable nonlinearity enhanced frequency up-conversion and rack-pinion mechanisms to efficiently harness structural and biomechanical vibration energy. In the present design, two frequency up-conversion piezoelectric generators, an array-type electromagnetic generator and a sliding-mode triboelectric nanogenerator are integrated together to form a compact and interactive system. By utilizing the rack-pinion mechanism, the relative speed between the stators and the translators of the electromagnetic and triboelectric generators are both doubled. Meanwhile, the process of frequency up-conversion in the piezoelectric generators is also doubled per each cycle. This results in better performance under wideband and low-frequency vibration sources. For verification, a prototype of this design is tested by mechanical excitations and body-induced motions. In the shaker test, the prototype can generate a peak output power of 446.16 mW under an optimal resistance load, resulting in a normalized power density of 4.20 mW cm −3 g −2 at 5 Hz under 1 g. The prototype also exhibits exceptional performance under various human motion tests, it can drive 600 commercial light-emitting diodes simultaneously. Using a commercial DC/DC voltage regulator circuit, the proposed harvester can serve as a universal power source to charge commercial electronic devices, including smartphones and GPS sensors. The present design shows great potential as a sustainable power source for wearable/portable electronics as well as wireless monitoring systems.

A Self-Powered Power Supply Management Circuit Using Frequency Conversion Network

A High-Efficiency Piezoelectric Energy Harvesting and Management Circuit Based on Full-Bridge Rectification

A Power Management Circuit for Electrical Field Energy Harvester

A High-Efficiency Management Circuit for Weak Piezoelectric Energy Harvester

An Ultra-Low Quiescent Current Power Management ASIC with MPPT for Vibrational Energy Harvesting

A Passive Design Scheme to Increase the Rectified Power of Piezoelectric Energy Harvesters

Duty Cycle Tuning Matching Circuit for Piezoelectric Vibrating Energy Harvesting.

Note: Weak Acoustic Energy Harvesting and High-Efficiency Storage-Energy Management Circuit for Wireless Sensor

Inductor Energy Storage Power Management Circuit for Micro-Power Piezoelectric Energy Harvester

A Nail-Size Piezoelectric Energy Harvesting System Integrating a MEMS Transducer and a CMOS SSHI Circuit

An Ultralow Quiescent Current Power Management System with Maximum Power Point Tracking (MPPT) for Batteryless Wireless Sensor Applications

Self-powered Ultra-Low-power Low-Threshold Synchronous Circuit for Weak Piezoelectric Energy Harvesting

A Self-Powered Ultra-Low-power Intermittent-Control SSHI Circuit for Piezoelectric Energy Harvesting

An Energy Management Circuit Based On Up-Conversion To Power Wireless Sensor Nodes

Adaptive Capacitor Charging Circuit with Simplified Configuration for Efficient Piezoelectric Energy Harvesting

Piezoelectric Micro-power Generation to Charge Supercapacitor with Optimized Duty Cycle

Power management circuit for a vibration energy self-powered wireless sensor

Self-powered piezoelectric energy harvesting with ultra-low power consumption for low-amplitude ambient vibrations

Design and Implementation of an Opamp Based Interface Circuit for Improving the Output Power of Frequency Up Conversion Piezoelectric Energy Harvester

A Fully-Integrated Kinetic Energy Harvesting Circuit with a Transposed Hybrid Series-Parallel SC DC-DC

A speed-amplified tri-stable piezoelectric-electromagnetic-triboelectric hybrid energy harvester for low-frequency applications