Abstract:Crystallization of poly(butylene terephthalate) (PBT) thin films from the glassy state has been investigated. The thin films on the silicon substrate with a thickness of no more than 300 nm were prepared by spin-casting and were examined by grazing-incidence X-ray scattering and atomic force microscopy before and after isothermal annealing at various temperatures (T(a)s). It is found that the virgin spin-cast thin films are anisotropic amorphous, with the PBT chains preferentially lying down on the substrate. The phase structure and morphology of the annealed thin films are strongly T-a-dependent. At T(a)s below 80 degrees C, the thin films remain amorphous due to the restricted chain segment mobility imposed by the one-dimensional (1D) confinement of the thin film. For T-a of 80-180 degrees C, isothermal annealing results in dominantly smectic nodules with a size of around 10 nm, which can be sustained regardless of extending the annealing time. When T-a is in the range of 180-200 degrees C, lath-like PBT crystals of alpha-form, which are edge-on lamellae, are observed to coexist with the smectic nodules. Further increasing T-a allows the lath-like crystals to grow substantially. However, owing to the high nucleation density, the crystals are small, showing a lateral size of just several dozens of nanometers. It is interesting to note that the 1D confinement condition could largely arrest the transformation from smectic-to-crystal over a wide temperature range, letting the smectic nodules survive at T-a below 200 degrees C. We further explored the interplay of smectic and crystal phases. It is unveiled that when the well-formed nodules are taken as the initial state for crystallization, the nodules can rapidly turn into nearly square-shaped crystal particles above 200 degrees C, which serve as the element blocks for the subsequent crystal growth. The combination of these blocks makes the lath-like crystals extend their lengths. Accordingly, we conjecture that when the PBT thin films are crystallized from the glassy state, there may exist a pathway of "glass-to-smectic-to-crystal".

Effects of Crystal Growth Conditions on Morphology of Crystalline Syndiotactic 1,2-Polybutadiene

Temperature‐dependent Polymorphic Crystalline Structure and Melting Behavior of Poly(butylene Adipate) Investigated by Time‐resolved FTIR Spectroscopy

Polymorphic Crystallization And Phase Transition Of Poly(Butylene Adipate) In Its Miscible Crystalline/Crystalline Blend With Poly(Vinylidene Fluoride)

Temperature-dependent Crystalline Structure and Phase Transition of Poly(butylene Adipate) End-Functionalized by Multiple Hydrogen-Bonding Groups

Crystallization behavior of syndiotactic and atactic 1,2-polybutadiene blends

Crystallization and phase behavior of crystalline syndiotactic 1,2-polybutadiene/isotactic polypropylene blends in solution-cast thin films

Lateral Habits of Single Crystals of Metallocene-Catalyzed Low Molecular Weight Short Chain Branched Polyethylene from the Melt

Effects of self-seeding nucleation on crystallization behavior of syndiotactic 1,2-polybutadiene

Kinetics of Non-Isothermal Crystallization of Syndiotactic 1,2-Polybutadiene

Morphological Confinement on Crystallization in Blends of Poly(oxyethylene-<i>b</i><i>lock</i>-oxybutylene) and Poly(oxybutylene)

TEM Studies on Single Crystal Structure of Syndiotactic Poly(Propene-<i>co</i>-butene-1)s

Single Crystal Structure of Form I Syndiotactic Poly(butene-1)

Morphologies of metallocene-catalyzed short chain branched polyethylene single crystals formed from the melt at higher temperature

Direct Formation of Isotactic Poly(1-Butene) Form I Crystals in Solution-Cast Thin Films

Polymorphic Crystalline Structure and Diversified Crystalline Morphology of Poly(butylene Adipate) Blended with Low‐molecular‐mass Liquid Crystals

An AFM study on the structure and melting behavior of melt-crystallized isotactic poly(1-butene)

Crystal Structure of Syndiotactic Poly(β-hydroxybutyrate) from X-ray Fiber and Powder Diffraction Analyses and Molecular Modeling

Tensile deformation mechanism of propylene-1-butene random copolymer: The role of initial crystalline morphology

Investigation on synthesis of high vinyl polybutadiene with iron-based catalysts I. Effect of triphenyl phosphate

Thin-Film Crystallization of Poly(butylene Terephthalate) from the Anisotropic Amorphous State

Crystalline Structure of Polypropylene Catalloys and Related Influence Factors