Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Numerical Filling Simulation of Injection Molding Based on 3D Finite Element Model

Three-dimensional Finite Element Method for the Filling Simulation of Injection Molding

Numerical Simulation of the Filling Stage in Injection Molding Based on a 3D Model

Numerical simulation of filling flow of polymer melt in injection molding

New Approach to Develop a 3D Non-Isothermal Computational Framework for Injection Molding Process Based on Level Set Method

A numerical filling simulation of injection molding using a 3D surface model

A Numerical Simulation of the Filling Stage in Injection Molding Based on a Surface Model

3D Filling Simulation of Injection Molding Based on the Pg Method

Computer Filling Simulation Of Injection Molding Based On 3d Surface Model

An Improved Algorithm for the Simulation of Injection-Molding Filling Process

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

3D Simulation of Filling Stage of Plastic Injection Molding Based on Improved Finite Volume Method

Numerical Simulation of Polymer Filling Process by a Combined Finite Element/discontinuous Galerkin/level Set Method

Simulations of a Full Three‐dimensional Packing Process and Flow‐induced Stresses in Injection Molding

3D Numerical Simulation of Gas-assisted Injection Molding

Numerical Simulation of Melt Filling and Gas Penetration in Gas Assisted Injection Molding

A robust finite volume method for three-dimensional filling simulation of plastic injection molding

3D Flow Simulation for Viscous Nonisothermal Incompressible Fluid in Injection Molding

Visualization and Simulation of Filling Process of Simultaneous Co-Injection Molding Based on Level Set Method

Surface Model Based Modeling and Simulation of Filling Process in Gas-Assisted Injection Molding

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process