Abstract:Conventional spacecraft Guidance, Navigation, and Control (GNC) architectures have been designed to receive and execute commands from ground control with minimal automation and autonomy onboard spacecraft. In contrast, Artificial Intelligence (AI)-based systems can allow real-time decision-making by considering system information that is difficult to model and incorporate in the conventional decision-making process involving ground control or human operators. With growing interests in on-orbit services with manipulation, the conventional GNC faces numerous challenges in adapting to a wide range of possible scenarios, such as removing unknown debris, potentially addressed using emerging AI-enabled robotic technologies. However, a complete paradigm shift may need years' efforts. As an intermediate solution, we introduce a novel visual GNC system with two state-of-the-art AI modules to replace the corresponding functions in the conventional GNC system for on-orbit manipulation. The AI components are as follows: (i) A Deep Learning (DL)-based pose estimation algorithm that can estimate a target's pose from two-dimensional images using a pre-trained neural network without requiring any prior information on the dynamics or state of the target. (ii) A technique for modeling and controlling space robot manipulator trajectories using probabilistic modeling and reproduction to previously unseen situations to avoid complex trajectory optimizations on board. This also minimizes the attitude disturbances of spacecraft induced on it due to the motion of the robot arm. This architecture uses a centralized camera network as the main sensor, and the trajectory learning module of the 7 degrees of freedom robotic arm is integrated into the GNC system. The intelligent visual GNC system is demonstrated by simulation of a conceptual mission-AISAT. The mission is a micro-satellite to carry out on-orbit manipulation around a non-cooperative CubeSat. The simulation shows how the GNC system works in discrete-time simulation with the control and trajectory planning are generated in Matlab/Simulink. The physics rendering engine, Eevee, renders the whole simulation to provide a graphic realism for the DL pose estimation. In the end, the testbeds developed to evaluate and demonstrate the GNC system are also introduced. The novel intelligent GNC system can be a stepping stone toward future fully autonomous orbital robot systems.

Distributed Simulation Method for Homing Missiles Guidance, Navigation, and Control.

Development of integrated computer environment for numerical optimization and simulation toward autonomous parafoil delivery

Simulation of Missile-borne Active Bait' S Decoying Process in Interfering with Missile

Design of surface vessel EW simulating training system

Immersive virtual simulation system design for the guidance, navigation and control of unmanned surface vehicles

Cooperative Guidance Law with Maneuverability Awareness: A Decentralized Solution

Distributed Control of Unmanned Marine Vehicles for Target Circumnavigation in Communication-Denied Environments

Study on Missile Homing Loop Performance Analysis Methods

Simulation System for Distributed Satellites Formation

Model Predictive Guidance for Active Aircraft Protection from a Homing Missile

Network Attack-Defense Simulation Training System Based on HLA

Intelligent Spacecraft Visual GNC Architecture With the State-Of-the-Art AI Components for On-Orbit Manipulation

Fixed-Time Distributed Event-Triggered Cooperative Guidance Methods for Multiple Vehicles with Limited Communications to Achieve Simultaneous Arrival

Distributed Gnss Collaborative Localization: Theoretical Performance Analysis and Simulation Verification

Integrated Missile Guidance and Control Using Adaptive Sliding Mode Approach

Evaluation and enhancing missile performance via real time flight simulation model

Three-Dimensional Integrated Guidance and Control for Near Space Interceptor Based on Robust Adaptive Backstepping Approach

Coordinated Navigation Control of Cross-Domain Unmanned Systems via Guiding Vector Fields

Development of multisensor integrated navigation system based on distributed multiprocessor

Non-singular terminal dynamic surface control based integrated guidance and control design and simulation

Studies on Multi-Constraints Cooperative Guidance Method Based on Distributed MPC for Multi-Missiles