Abstract:The ground vibrations due to underground moving trains cause disturbances to nearby buildings and their residents, which has been viewed as an important environmental issue. Various numerical or semi-analytical models are used to calculate the vibrations from underground railways, however, most of the prediction models adopt a single tunnel-soil system for modelling vibrations from underground trains and neglect the influence of a neighboring tunnel. In this paper, a semi-analytical wave function method is proposed for modelling vibrations from twin tunnels in a multi-layered viscoelastic and poroelastic half-space. The two tunnels are modelled as two hollow cylinders while the surrounding soil is modelled as a multi-layered half-space containing two circular cavities. The vibrations of the tunnel walls are taken as a superposition of outgoing and regular cylindrical waves. The wave field in the soil layer containing two cavities consists of down-going and up-going plane waves and cylindrical waves propagating outwards from each tunnel. In the wave function method, the transformation and translation of the plane and cylindrical waves make it possible to apply the boundary conditions at the scattering surfaces. Numerical results show that the half-space model predicts higher surface vibrations than a full-space model at equivalent surface locations. When the second tunnel is added near a deeper existing tunnel, a wider range of the free-field response above the two tunnels is significantly changed, however, the response below twin tunnels is less affected. If the separation distance between the two tunnels is smaller than five times the tunnel diameter, a twin tunnel model in a half-space is more suitable for an accurate vibration prediction at the ground surface. The cutoff effect of the rigid base is more visible for shallow bedrock at lower frequencies while the influence of the bedrock is quite limited at higher frequencies.

Time-Domain Boundary Element Method for Underground Structures in Orthotropic Media

Vibration of layered saturated ground with a tunnel subjected to an underground moving load

Analytical Wave Function Method for Modelling a Twin Tunnel Embedded in a Saturated Poroelastic Full-Space

The Wave Function Method for Calculation of Vibrations from a Twin Tunnel in a Multi-Layered Half-Space

The Influence of a Neighboring Tunnel on the Critical Velocity of a Three-Dimensional Tunnel-Soil System

Closed-Form Analytical Solution for Vibrations from A Tunnel Embedded in A Saturated Poroelastic Half-Space

The Influence of Pore-Fluid in the Soil on Ground Vibrations from a Tunnel Embedded in a Layered Half-Space

Study of vibration-isolation efficiency of open trench in saturated ground by 2.5D finite element method

Analytical Solution for Calculating Vibrations from Twin Circular Tunnels

Analytical and Experimental Study on Wave Propagation Problems in Orthotropic Media

An Analytical Model for Calculating Vibrations from Twin Tunnels in a Saturated Poroelastic Half-Space

Enhanced Theoretical Approach for Predicting the Tunnel Response Due to Deep Excavation Above

Benchmark Solution for Vibrations from a Moving Point Source in a Tunnel Embedded in a Half-Space

A 2.5D Finite Element Method Combined with Zigzag-Paraxial Boundary for Long Tunnel under Obliquely Incident Seismic Wave

An Analytical Solution to Investigate the Dynamic Impact of a Moving Surface Load on a Shallowly-Buried Tunnel

Infinite Boundary Elements for Dynamic Problems of 3‐D Half Space

Analytical Solutions for a Deep-Buried Tunnel with Noncircular Cross Sections in Orthotropic Rock Mass

A Numerical Study on the Transverse Seismic Response of Lined Circular Tunnels under Obliquely Incident Asynchronous P and SV Waves

Finite element modeling of wave propagation problems in multilayered soils resting on a rigid base

Seismic analysis of underground tunnels subjected to 3D oblique incident P and SV waves by 2.5D approach

Analytical approach for evaluating the dynamic response of underground structure to p seismic waves