Abstract:This article presents a heterodyne experiment which uses a 380-520 GHz planar circuit balanced Nb-$\mathrm{Al_2O_3}$-Nb superconductor-insulator-superconductor (SIS) quasiparticle mixer with 4-8 GHz instantaneous intermediate frequency (IF) bandwidth to quantitatively determine local oscillator (LO) noise. A balanced mixer is a unique tool to separate noise at the mixer's LO port from other noise sources. This is not possible in single-ended mixers. The antisymmetric IV characteristic of a SIS mixer further helps to simplify the measurements. The double-sideband receiver sensitivity of the balanced mixer is 2-4 times the quantum noise limit $h\nu/k_B$ over the measured frequencies with a maximum LO noise rejection of 15 dB. This work presents independent measurements with three different LO sources that produce the reference frequency but also an amount of near-carrier noise power which is quantified in the experiment as a function of the LO and IF frequency in terms of an equivalent noise temperature $T_{LO}$. In a second experiment we use only one of two SIS mixers of the balanced mixer chip, in order to verify the influence of near-carrier LO noise power on a single-ended heterodyne mixer measurement. We find an IF frequency dependence of near-carrier LO noise power. The frequency-resolved IF noise temperature slope is flat or slightly negative for the single-ended mixer. This is in contrast to the IF slope of the balanced mixer itself which is positive due to the expected IF roll-off of the mixer. This indicates a higher noise level closer to the LO's carrier frequency. Our findings imply that near-carrier LO noise has the largest impact on the sensitivity of a receiver system which uses mixers with a low IF band, for example superconducting hot-electron bolometer (HEB) mixers.

Low Noise Receivers Based on Superconducting Niobium Nitride Hot Electron Bolometer Mixers from 0.65 to 3.1 Terahertz

Low Noise Receivers Using Niobium Nitride Hot Electron Bolometer Mixers from 0.76 to 3.1 THz

Low Noise Receivers at 1.6 Thz and 2.5 Thz Based on Niobium Nitride Hot Electron Bolometer Mixers

Superconducting Nbn Hot Electron Bolometer Mixer at Terahertz

Terahertz Detectors Based on Superconducting Hot Electron Bolometers

Heterodyne Mixing and Direct Detection Performance of a Superconducting NbN Hot-Electron Bolometer

Noise Behaviour Of A Thz Superconducting Hot-Electron Bolometer Mixer

Enhanced Sensitivity of THz NbN Hot Electron Bolometer Mixers

An Ultra-High-Sensitivity Superconducting Hot-Electron-Bolometer Heterodyne Receiver at 2.5 THz with an Integrated Low-Power-Consumption Quantum Cascade Laser

Characterization of a Quasi-optical NbN Superconducting Hot-electron Bolometer Mixer

Low Noise HEB/QCL Integrated Heterodyne Receiver at 2.7 THz

Direct Measurement of the Input RF Noise of Superconducting Hot Electron Bolometer Receivers

Low-Noise 0.5 Thz All-Nbn Superconductor-Insulator-Superconductor Mixer for Submillimeter Wave Astronomy

Characterization of A Quasi-Optical Nbn Superconducting Heb Mixer

Stability of Superconducting Hot Electron Bolometer Receivers

Investigation of the Performance of NbN Superconducting HEB Mixers of Different Critical Temperatures

Dependence of Noise Temperature of Quasi-Optical Superconducting Hot-Electron Bolometer Mixers on Bath Temperature and Optical-Axis Displacement

Noise Performance of a 200–280 GHz Mixer with Nb-AlN-NbN Superconducting Tunnel Junctions

Effect of NbN-Au Contact Pads on the Performance of a Superconducting NbN Hot Electron Bolometer Mixer

A 490 GHz planar circuit balanced Nb-Al$_\mathbf{2}$O$_{\mathbf{3}}$-Nb quasiparticle mixer for radio astronomy: Application to quantitative local oscillator noise determination

Appropriate Microwave Frequency Selection for Biasing Superconducting Hot Electron Bolometers As Terahertz Direct Detectors