Model identification and control method of electro-hydraulic position servo system

SHAO Jun-peng,HAN Gui-hua,DONG Yu-hong,Jiachun Liu

2008-01-01

Abstract:Mathematic model of electro-hydraulic position servo test bench was obtained based on xPC hardware-in-the-loop simulation technique and system identification toolbox in MATLAB,using step signal as the input and hydraulic cylinder position as the output. A hybrid controller composed of a classical PID controller and a fuzzy controller was designed based on the mathematic model. The integrating factor and the modifying factor were applied in controller,and interpolation method was used in the modifying factor fuzzy number model. A fuzzy switching mode was employed to avoid the undesirable disturbances caused by the switchover between the two control methods,and execution area of the fuzzy switchover can be set by membership function. The hardware-in-the-loop simulation results show that the steady-state error is eliminated for fuzzy control and rapidity for PID control is enhanced,the comprehensive performance of electro-hydraulic position servo system is improved and adaptability for plant changing parameters(load mass)is enhanced by the hybrid controller.