Abstract:Fused silica crucibles are commonly used in the fabrication process of solar grade silicon ingots. These crucibles are manufactured from high purity natural quartz sand and as a consequence, their properties are influenced by the presence of water and hydroxyls in the raw quartz. In this work, diffuse reflectance IR, 1H magic angle spinning NMR, and Raman spectroscopy were used to investigate the influence of thermal treatment on water and hydroxyl groups in high purity natural quartz sand. Most of the water in dry sand is present in the form of closed inclusions within the quartz grains which were detected in Raman imaging studies, even after thermally treating the samples at 600 °C. Only after heating to 900 °C did this water completely vanish, most likely as a result of rupturing of the inclusions. However, newly formed OH groups, identified as isolated and hydrogen bound OH were observed as products of the reaction between water and quartz. Similarly, liquid water was observed in NMR spectra even after treatment at 600 °C while at temperatures >900 °C, only non-interacting silanol groups were present. The comparison of the temperature dependence of the IR and NMR spectra also yields insight into the assignment of the OH stretching mode region of the IR spectrum in this system. The intensity of water related bands decreases while the intensity of OH bands first increases and then decreases with increasing temperature. The band intensity of Al-rich defects as well as the characteristic feature at 3200 cm-1 does not follow the temperature dependence of typical water peaks. It is also shown that leaching the quartz sand in HF solution helps to remove water from inclusions, likely by forming pathways for fluid flow inside the quartz grains. Milling of the samples caused formation of an additional type of hydroxyl group, possibly due to partial amorphisation of the surfaces of the quartz grains surface during the process. The results improve the basis for a knowledge-based processes development for the processing of high purity natural quartz.

High-temperature hydroxylation of alumina crystalline surfaces

The Role of Surface Hydroxyl Concentration on Calcinated Alumina in Catalytic Ozonation

Effects of Heat Treatment on Structure Transformation of Cr/Al Composite Coatings

A preliminary FTIR study of structural hydroxyl in pyroxenes at varying temperatures

High Field 27al MAS NMR and TPD Studies of Active Sites in Ethanol Dehydration Using Thermally Treated Transitional Aluminas As Catalysts

Effect of Heat Treatment on Structural and Mechanical Properties of Alloyed Fused Alumina

Molecular Dynamics Study of Substrate Temperature and Incident Energy Influence on the Crystallization Behavior of Alumina Thin Film Deposition Process

Structural evolution of water and hydroxyl groups during thermal, mechanical and chemical treatment of high purity natural quartz

Effect of hydrothermal treatment on the acidity distribution of γ-Al2O3 support

Effect of heat‐treatment on the microstructure and room‐temperature mechanical properties of alumina–silica fiber

Low-Temperature Crystallization and Hardness Enhancement of Alumina Films Using the Resputtering Technique

Influence of Sulfur and Water Vapor on High-Temperature Oxidation Resistance of an Alumina-Forming Austenitic Alloy

Effects of −OH Groups on Fe3O4 Particles on the Heterogeneous Coating in a Hydrous Alumina Coating Process

Stabilizing nanocrystalline oxide nanofibers at elevated temperatures by coating nanoscale surface amorphous films.

Fluorination of an Alumina Surface: Modeling Aluminum-Fluorine Reaction Mechanisms

Effect of Aqueous Ammonia Medium and Fluorine Treatment on Properties of Alumina-Pillared Clays

Preparation Of Alpha-Al2o3 Thin Films By Electron Cyclotron Resonance Plasma-Assisted Pulsed Laser Deposition And Heat Annealing

Infrared Spectroscopy Studies of Aluminum Oxide and Metallic Aluminum Powders, Part I: Thermal Dehydration and Decomposition

Strength degradation of alumina fiber: Irreversible phase transition after high-temperature treatment

Quantification of surface orientation effect on the thermal stability of γ-Al2O3 with different morphologies