Abstract:Whole fraction low-temperature coal tar (LTCT) has a high content of heavy compounds, direct entry into an industrial reactor for hydrotreating (HDT) conversion into fuel oil is a new technology that has not been widely reported. Furthermore, a copious amount of heat is generated, resulting in hot spots and temperature flying on the catalyst bed. This study uses the gPROMS software, based on the kinetic parameters which are determined from several HDT reactions using experimental data in small-scale TBR, combined with energy balance and mass transfer equations among three phases to construct industrial TBR model with a treatment capacity of 250,000 tons/year. This model was used for simultaneous HDS and HDN process simulation. The Simulation results show that the sharp temperature rise along the catalyst bed length can arrive at 70 K without quenching, which is obviously higher than that of petroleum distillate hydrogenation. So, a optimal bed configuration of equal bed lengths and unequal bed inlet temperature was established by simulating and optimizing the reactor. with each bed 350 cm in length and inlet temperatures of 633 K, 643 K, 653 K, and 653 K, respectively, it has a reasonable temperature rise distribution, lower added hydrogen quench amount of 47360.65 Nm(3)/h, while sulfur and nitrogen removal rates can reach 87.55% and 86.46%, showing better performance than that of a small scale reactor. Hydrogen quenching not only lowers the temperature of the mixture and replenishes the chemical hydrogen consumption but also facilitates the removal of S, N heteroatom compounds. The results can provide a guidance for bed configuration for whole fraction LTCT industrial hydrogenation devices.

Optimization for Hydrodenitrification Process of Coal Tar Using Response Surface Methodology

Optimization for the Hydrocracking Process of the Heavy Fraction of Medium Temperature Coal Tar

Optimization of hydrogenation dearomatization process for coal tar

A Study on Hydrodesulfurization Process of Coal Tar

Optimization of Processing Parameters and Macrokinetics for Hydrodesulfurization of Coal Tar

HYDRO-UPGRADING PROCESS OF MEDIUM AND LOW TEMPERATURE COAL TAR

Influence of Process Conditions on Product Distribution of Coal Tar Hydrogenation

Optimization of Reaction Variables and Macrokinetics for the Hydrodeoxygenation of Full Range Low Temperature Coal Tar

Optimization of Electrical Desalting Process of Coal Tar Using Response Surface Methodology

The Hydrodeoxygenation, Hydrogenation, Hydrodealkylation and Ring-Opening Reaction in the Hydrotreating of Low Temperature Coal Tar over Ni–Mo/γ-Al2O3 Catalyst

Lumped Kinetic Simulation of Hydrodenitrogenation for Full-Range Middle-Low Temperature Coal Tar

Modelling and Simulation of Industrial Trickle Bed Reactor Hydrotreating for Whole Fraction Low-Temperature Coal Tar Simultaneous Hydrodesulfurisation and Hydrodenitrification

Hydrogention conversion path of mid-low-temperature coal tar

Kinetic Model for Low-Temperature Coal Tar Hydrorefining

Optimization for Electrochemical Dehydration Process of Coal Tar Using Response Surface Methodology

Kinetics for Hydrodesulfurization of Coal Tar

Effects of reaction temperatures on the properties and chemical composition of hydrogenated products of low temperature coal tar

Hydrofining Process of Coal Tar Based on Four Kinds of Catalyst Grading

Study on Hydrogen Consumption of Coal Tar Hydrogenation

Hydrogenation and Product Distribution of Low Temperature Coal Tar

Catalyst Screening and Product Distribution of Low Temperature Coal Tar Hydrogenation