Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

Analysis of factors affecting suction volumetric efficiency of large caliber piston pumps

Study on methods of real-time measuring suction volumetric efficiency of large-calibered piston pumps

Characteristics of Volumetric Losses and Efficiency of Axial Piston Pump with Respect to Displacement Conditions

Experimental Research on Paper Sludge Suction Characteristic of the Piston Pump

Study on Friction Characteristics of Slipper Pair of Large Displacement High-Pressure Piston Pump

Research on Test Device of Suction Characteristic for High Concentration and Viscous Materials

Experimental study on the sucking characteristics of the piston pump to calcium carbide slurry

The Optimization of A Low Specific Speed Pipeline Pump

Research on the Volumetric Efficiency of 2D Piston Pumps with a Balanced Force

Design of Mechanical System of Suction Characteristic Testing Device

Theoretical and Experimental Investigation on the Efficiency of a Novel Roller Piston Pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Investigation of the integrated model of side chamber, wear-rings clearance and balancing holes for centrifugal pumps

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Optimization of the Outlet Unloading Structure to Prevent Gaseous Cavitation in a High-Pressure Axial Piston Pump

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Volumetric efficiency of a high-pressure supply pump for high-pressure common rail systems

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Improvement Design of a Vertical Double-stage Self-priming Pump

Test of coal slime pumping by single-screw pump

Raising the Speed Limit of Axial Piston Pumps by Optimizing the Suction Duct