Abstract:Background, aims and scope: Hexavalent chromium [Cr(VI)] cannot react with either carbonate or hydroxide to form chromium precipitates. However, by using a precipitation technology to treat plating wastewater containing Cr(VI), Cu(II), Ni(II) and Zn(II), approximately 78% of Cr(VI) (initial 60 mg/L) was co-removed with the precipitation of Cu(II), Ni(II) and Zn(II) (each 150 mg/L) by dosing with Na2CO3 (Sun 2003). Direct precipitation by forming Cu(II)-Cr(VI) precipitates followed by adsorption of Cr(VI) onto freshly formed Cu-precipitates was subsequently found to be the main mechanism(s) involved in Cr(VI) co-removal with Cu(II) precipitation by dosing Na2CO3 stepwise to various pH values (Sun et al. 2003). This study was. carried out to further characterize the formation of primary precipitates during the early stages of copper precipitation and simultaneous removal of Cr(VI) with Cu(II). Methods: Test metal-solutions were prepared with industrial grade chemicals: CuCl2 x 2H2O, Na2SO4 and K2Cr2207. NaCO3 was added drop-wise to synthetic metal-solution to progressively increase pH. For each pH increment, removal of soluble metals was detected by atomic absorption spectrophotometer (AAS) and surface morphology of precipitates was analyzed by scanning electron microscope (SEM). To further characterize the formation of primary precipitates, a series of MINEQL+ thermodynamic calculations/analyses and equilibrium calculations/ analyses were conducted. Results and discussion: MINEQL+ thermodynamic calculation indicated that, for a system containing 150 mg/L Cu(II) and 60 mg/L Cr(VI) with gradual Na2CO3 dosing, if any precipitates can be formed at pH 5.0 or lower, it should be in the form of CuCrO4. Comparison tests using systems containing the same equivalent of Cu(II) plus Cr(VI) and Cu(II) plus SO4(2-) showed that the precipitation occurred at a pH of around 5.0 in the Cu(II)-Cr(VI) system and around 6.0 in the Cu(II)-SO4(2-) system. The discrepancy of the precipitation was indeed caused by the formation of Cu-Cr precipitates. The initiation of copper removal at pH around 5.0 for the Cu-Cr co-removal test was not attributable to the formation of Cu-CO3 precipitates, instead, it was most likely through the formation of insoluble Cu-Cr precipitates, such as CuCrO4 and CuCrO4 x 2Cu(OH)2. Experimental tests, equilibrium calculations, MINEQL+ thermodynamic calculations and surface morphologies for systems using higher concentrations of Cu(II) and Cr(VI) further verified the most probable composition of primary precipitates is copper-chromate. Conclusion: In the Cu-Cr co-removal test with Na2O3 dosing to increase pH and induce metal precipitation, copper-chromate precipitates are the primary precipitates produced and contribute to the initial simultaneous removal of copper and chromium.

Mechanism of Crud Formation in Copper Solvent Extraction

Mechanism of Forming Filth in Copper Solvent Extraction

EXTRACTION OF COPPER(Ⅱ)ION BY CHEMICAL COMPLEXATION WITH LIX984

Mechanism of Limited Coalescence of Interfacial Emulsion in Copper Solvent Extraction

Extraction of Copper from Pregnant Leach Solution (PLS) and Reduction of Crud Formation

The Testing Results of ACORGA, LIX Extractants and CR60 Crud Mitigation Reagent Influence during SX-EW Copper Extraction

Interfacial emulsion formation originated from organic phase in copper solvent extraction

Investigation Into the Formation Mechanisms of Soluble Copper Ions in Oil: Reconsidering the Impact of Corrosive Sulfides and Acids

Effects of Strong-Acid on Performances of Copper Solvent Extraction

Speciation of copper in a contaminated soil during H3PO4-assisted EKR

Review on micro-mechanism of forming emulsification during rare earth extraction by acidic extractants

Solvent Extraction of Copper and Zinc from Bioleaching Solutions with LIX984 and D2EHPA

Effect of Diluent on Interfacial Emulsion in Copper Solvent Extraction

Study on Cu(II) extraction process optimization and mechanism from acidic leaching solution using the deep eutectic solvent P507/Menthol

Behavior of Copper in Solution after Removing Molybdenum by Selective Precipitation

Phase Separation in Solvent Extraction of Copper or Nickel from Acidic Solution Using a Sulfonic Acid (HDNNS) and a Carboxylate Ester (4PC)

Characterization of primary precipitate composition formed during co-removal of Cr(VI) with Cu(II) in synthetic wastewater

Separation of Zinc from Acid-in-extractant Leaching Solution of Copper Converter Dust

Optimization Study Of Operation Parameters For Extracting From Sulfuric Solution Containing With Lix984n In A Laminar Microchip

Demulsification Behavior of Alkali and Organic Acid in Zinc Extraction

Experimental and Computational Investigation of Complexing Agents on Copper Dissolution for Chemical Mechanical Polishing Process