Abstract:This paper focuses on the mechanisms of combustion noise during the accelerating operation of multi-cylinder diesel engines using testing technology for the transient conditions of IC engines. Based on impact factors, such as the gas dynamic load and cylinder pressure oscillations, tests and analysis of the combustion noise during transient and steady-state conditions for different loads are made on four-cylinder naturally aspirated engines, turbocharged engines, EGR-introduced engines, and high pressure common rail engines. The laws of combustion noise difference for the same engine speed and load are researched during transient and steady-state conditions. It is found that during transient conditions, the maximum pressure rise rate and the high frequency oscillation amplitude of the cylinder pressure are all higher than those observed during steadystate conditions for the same engine speed and load. With their joint action, the combustion noise during transient conditions is greater than that during steady-state conditions. Turbocharging is useful in reducing the combustion noise during transient conditions. Turbocharging has a better effect on the control over the combustion noise during transient conditions with a constant engine speed and an increasing torque than in conditions with a constant torque and an increasing engine speed. One of the main reasons for different control effects on the combustion noise is that turbocharging causes different wall temperatures inside combustion chambers. The introduction of the appropriate EGR is helpful in the reduction of the combustion noise during transient conditions. The key to the control of combustion noise with EGR during transient conditions is whether a real-time adjustment to the EGR rate can be made to achieve the optimization of the EGR rates for different transient conditions. By means of analyzing the differences in the combustion noise between the transient and steady-state conditions for different pilot injection controls, we obtain a strategy for controlling the combustion noise during transient conditions with a pilot injection. Compared with the steady-state conditions, a larger pilot injection quantity and a longer interval between the main injection and pilot injection should be selected for transient conditions, and this is verified through tests.

Controlling Research of Pilot Injection and Rail Pressure Parameter for Idle Speed Noise of Electronic Controlled Diesel Engine

Experimental Study of Pilot Injection Control Strategies for Combustion Noise in Transient Conditions of Diesel Engine

Effect of Injection Parameters on Vibration of High Pressure Common Rail Diesel Engine for Light Vehicle at Idle Speed

Mechanism and Optimization of Fuel Injection Parameters on Combustion Noise of DI Diesel Engine

Influence of the Accelerating Operation Mechanism on the Combustion Noise in DI-diesel Engines

Study on the Combustion Noise Control of DI-Diesel Engines under Transient Conditions

Investigation on the Combustion Noise of a Pilot-Ignited Direct-Injection Natural-Gas Engine

Research on Injection Control Strategy for High Pressure Common Rail Diesel Engine

Effects of Pilot Injection Timing on the Combustion Noise and Particle Emissions of a Diesel/natural Gas Dual-Fuel Engine at Low Load

Research on the Control Strategy of Fuel Injection System with Electronic Unit Pump

Study on the Relationship Between Adjustable Operational Parameters and Noise of Single-Cylinder Diesel Engine

Study on noise of rapeseed oil blends in a single-cylinder diesel engine

Simulation of the Effect of Fuel Injection Rate that Matches Fuel Injection Advanced Angle on the Performance of Ultra High Pressure Common Rail Diesel Engine

Effects of Injection Parameters on the Combustion and Emission Characteristics of Diesel-Piloted Direct-Injection Natural Gas Engine during Idle Conditions

Effect of Pilot Injection Strategy on Performance of Diesel Engine under Ethanol/F-T Diesel Dual-Fuel Combustion Mode

Experimental Research of Starting Control of GD-1 High Pressure Common Rail Diesel Engine

Optimization of hydraulic system for electronic control of diesel fuel injection

Research of Rail Pressure Control Strategy on Common Rail Fuel System

Experimental Studies on the Key Parameters Controlling the Combustion and Emission in Premixed Charge Compression Ignition Concept Based on Diesel Surrogates

Influence of change of common-rail and high-pressure fuel pipe parameters in electric control system of diesel engine on system performance

Improvement of Emission Performance of Two-stroke Diesel Engines with Two-stage Injection