Toxicity of High-Sulfate Pharmaceutical Wastewater and Performance of SPAC Process

LU Huifeng,ZHENG Ping,ZHANG Meng,ZHANG Jiqiang,DING Shuang
DOI: https://doi.org/10.3969/j.issn.0438-1157.2012.05.034
2012-01-01
Abstract:The acute toxicity of typical pollutants(sulfate and sulfide)in high-sulfate pharmaceutical wastewater and effluent from SPAC reactor was tested using the 15 min half inhibitory concentration(IC50)to photobacterium.The results showed that the IC50 of sulfate and sulfide was 12077.8,78.1 mg·L-1,respectively;the IC50 of raw pharmaceutical wastewater,effluents from SPAC reactor with influents of 6-fold and 3-fold dilution were 64.5,44.7 and 78.9 times,respectively.The maximum volumetric COD,sulfate removal rates of SPAC reactor were 5.76,1.83 kg·m-3·d-1,COD and sulfate removal efficiency were 54.1% and 71.8% when the influent concentration was increased at a fixed HRT;the maximum volume COD,sulfate removal rates were 7.52,1.90 kg·m-3·d-1,COD and sulfate removal efficiency was 72.8% and 80.0% when the HRT was shortened at a fixed influent concentration.Low concentrations with high-flow rate made SAPC reactor run more efficiently.If the influent concentration exceeds inhibition concentration threshold,the pharmaceutical wastewater has a significant effect on performance of SPAC reactor.However,SPAC process showed a good ability to adapt the toxicity of high-sulfate pharmaceutical wastewater after a long term operation(about 3 months).The raw pharmaceutical wastewater should be diluted more than 5.13 folds to avoid the inhibition at the beginning of operation,while influent concentration could be increased to a dilution of 3.32-fold to cut the operation cost in the later.
What problem does this paper attempt to address?